713886

Quickie Life RT Manual

30
Zoom out
Zoom in
Previous page
1/116
Next page
ENGLISH
30
Life RT Rev.E
Fig. 6.45
The lap belt should be fixed so that the belt sits at an angle of 45
degrees across the user’s pelvis. The user should be upright
and be as far back as possible in the seat when correctly
adjusted. The lap belt should not allow the user to slip down in
the seat. (Fig. 6.46)
To fasten buckle:
Firmly push male buckle
into female buckle.
To release belt:
Press exposed sides of male
buckle and push towards
centre whilst gently pulling
apart.
WARNING!
• If in doubt about the use and operation of the lap belt then
ask your healthcare professional, wheelchair dealer, carer
or attendant for assistance.
• If you want to retrofit a lap belt, then please contact your
authorised Sunrise Medical dealer.
• The lap belt must be checked on a daily basis to ensure it
is adjusted correctly and free from any obstruction or
adverse wear.
• Sunrise Medical does not encourage the transportation of
any person in a vehicle using this lap belt as a method of
restraint.
Please see Sunrise Medical transit booklet for further
advice on transportation.
Fig. 6.46
Maintenance:
Check lap belt and securing components at regular intervals for
any sign of fraying or damage. Replace if necessary.
WARNING
The lap belt should be adjusted to suit the end user as detailed
above. Sunrise Medical recommends that the length and fit of
the belt be checked on a regular basis to reduce the risk of the
end user inadvertently re-adjusting the belt to an excessive
length.
Transit Wheels (Fig. 6.47)
Transit wheels should be used wherever your wheelchair would
be too wide if the rear wheels were used. After the rear wheels
have been removed with the aid of the quick-release axles, the
transit wheels can immediately be used to continue riding. The
transit wheels are mounted so that they are approx. 3
centimeters above the ground when not in use. They are thus
out of the way when riding, transporting, or when tipping to pass
over obstacles.
CAUTION!
Without rear wheels, your wheelchair has no wheel locks.
Transit Wheels
Fig. 6.47
7.0 Tyres and mounting
Solid rubber tyres are standard.
With pneumatic tyres always make sure that the tyres have the
correct air pressure, as otherwise the performance of the
wheelchair may be affected. If the tyre pressure is too low,
rolling resistance will increase, requiring more effort to move the
chair forward. Low tyre pressure also has a negative impact on
maneuverability. If the tyre pressure is too high, the tyre could
burst. The correct pressure for a given tyre is printed on the
surface of the tyre itself.
Tyres can be mounted the same way as an ordinary bicycle
tyre. Before installing a new inner tube, you should always
make sure that the base of the rim and the interior of the tyre
are free of foreign objects. Check the pressure after mounting
or repairing a tyre. It is critical to your safety and to the
wheelchair’s performance that regulation air pressure be
maintained and that tyres are in good condition.
… 30 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Quickie Life RT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Quickie Life RT in the language / languages: English, Dutch, Danish, French, Italian as an attachment in your email.

The manual is 3,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info