721962
23
Zoom out
Zoom in
Previous page
1/28
Next page
23
CARE AND MAINTENANCE
Follow all safety instructions for the proper use of the
disinfectant and/or cleaning agent before applying it
to your product. Failure to comply may result in skin
irritation or premature deterioration of upholstery and/
or power chair finishes.
Never hose off your power chair or place it in direct
contact with water. Your power chair has a painted, ABS
plastic body shroud that allows it to be easily wiped
clean with a damp cloth.
Never use any chemicals to clean a vinyl seat, as they
may cause the seat to become slippery or dry out and
crack. Use soapy water and dry the seat thoroughly.
Wheel Replacement
If you have pneumatic tires and you have a flat tire, you can
replace the tube. If your chair is equipped with a solid tire
insert, then you must replace the entire wheel assembly.
Replacement tires, tubes, and wheel assemblies are readily
available through your Quantum Rehab Provider.
The wheels on your power chair should only be serviced
or replaced by a Quantum Rehab Provider or a qualified
technician.
Be sure that the controller’s power is turned off and the
power chair is not in freewheel mode before performing
this procedure.
When changing a tire, remove only the five lug nuts,
then remove the wheel. If any further disassembly is
required, deflate the tire completely or it may explode.
Follow these easy steps for a quick and safe repair for
both pneumatic and solid tires:
1. Turn off the power to the controller.
2. Set the power chair up on blocks.
3. If you are changing a pneumatic tire, completely deflate
it before removing the wheel.
4. Remove the five (5) lug nuts from the wheel hub. See
figure 22.
5. Pull the wheel off of the hub.
6. Remove the screws and separate the front and rear rim.
See figure 23.
7. Remove the old tube from the pneumatic tire and replace
it with a new tube or replace the entire assembly if it is
a solid tire.
8. Screw together the two rim halves.
9. Slide the wheel back onto the hub.
10. Reinstall the five (5) lug nuts onto the wheel hub and
tighten.
11. Inflate the pneumatic tire to the psi/bar/kPa air pressure
rating indicated on each tire.
12. Remove the power chair from the blocks.
Figure 22. Drive Wheel
Figure 23. Drive Wheel Disassembled
WARNING!
WARNING!
Lug Nut
Wheel Hub
Front
Rim Half
Tube
Tire
Rear
Rim Half
Screws
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Quantum Q6 Edge 2.0 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Quantum Q6 Edge 2.0 in the language / languages: English as an attachment in your email.

The manual is 14,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Quantum Q6 Edge 2.0

Quantum Q6 Edge 2.0 User Manual - German - 32 pages

Quantum Q6 Edge 2.0 User Manual - Dutch - 28 pages

Quantum Q6 Edge 2.0 User Manual - Dutch - 44 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info