698709
13
Zoom out
Zoom in
Previous page
1/15
Next page
ENGLISH
25
24
Stereo connection
(speaker A)
8. You may now switch your M8 and P8 devices on using the power switches.
9. Move the M8 power switch (9) and P8 power switch (13) on the back sides of the
devices to the ON position. The standby LEDs on the front panels will now come
on.
10. Now press the On / Standby button (5) on the front of the P8 pre-amplifier or
the button (2) on the remote control to start your devices. The M8 is switched on
together with the P8, if there is a LINK connection between them.
11. If there is no LINK connection, you additionally have to press button (4) on the M8
front panel.
Note:
As your P8 / M8 uses a special power-saving standby circuit, you can always
switch on / off during normal operation using the On / Standby button on the unit
or the RC-2 remote control.
The RC-2 remote control makes it easier for you to change
your settings.
Mute (button 3)
Balance setting (buttons 6 & 7)
Multi-level adjustment of display brightness (button 15 / only for P8, A5, A3)
Input level setting for all inputs (button 14)
Example: Input level adjustment
Use buttons 8 (-) or 9 (+) to select the signal source and then press button 14 (Prog.)
and use the volume buttons (4 & 5) to set up the input volume to suit yourself. Press
button 14 (Prog.) once again to save the settings.
Technical Data M8
Input sensitivity for 1 W at 4 ohms -26 dBV
Input impedance 47 kOhm
Voltage gain 22/32/35 dB
Maximum input voltage 6 V
Maximum voltage at speaker output (Stereo) 50 V
Maximum voltage at speaker output (Mono) 70 V
Minimum loudspeaker impedance (Stereo) 2 ohms
Minimum loudspeaker impedance (Mono) 2 ohms
Stereo output power at 8 ohms 120 W
Stereo output power at 4 ohms 200 W
Mono output power at 8 ohms 240 W
Mono output power at 4 ohms 350 W
Frequency response 1 Hz - 110 kHz (-3 dB)
Harmonic distortion < 0.03%
A-weighted signal-to-noise ratio 85 dB
Mains power connection 115V / 230V, switchable
Power consumption (in normal mode) 25 W
Power consumption (at maximum volume) max. 1200 W
Power consumption (in standby mode) < 0.5W
Inputs 2 pairs of RCA, 1 pairs of XLR
Speaker outputs 2 x pair
12V Link Connection In + Out (short-circuit-proof) 3.5mm Mono minijack
Protective circuits Temperature, overload
Dimensions (W x H x D) 453 x 130 x 330 mm*
Weight 1,38kg
* Width including wooden sides, Height including feet, Depth with speaker terminals
Switch position
XLR and Stereo
On
Off
max. Power Consumption: 1,
2kW
Fuse:
100V / 115V:
T6.3,
A L250V
230V:
T3.15, A L250V
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
ACHTUNG
STROMSCHLAG GEFAHR
NICHT ÖFFNEN
ATTENTION
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
ATENCIÓN
RIESGO DE DESCARGA ELCTRICA
NO ABRIR
DO NOT REMOVE COVER. NO USER
-
SERVI CEABLE PARTS
INSIDE. REFER SER VICING TO QUALIFIED PERSO NNEL.
TO REDUCE THE RISK OF ELECTRICAL SHOCK OR FIRE, DO NOT
EXPOSE THIS APPLIANCE TO MOISTURE OR RAIN.
In Out
Link
Gain
Mono / Stereo
RCA / XLR
+3 / 0
/
-10 dB
quadral GmbH & Co. KG - Am Herrenuser Bahnhof 26-28 - D-30419 Hannover
Handmade in Germany
®
AURUM
Balanced In
Right
Left
Mono In
Unbalanced In
Right
Left
Mono In
A B
Right
+ +
Mono
AB
Left
+ +
Mono+
Fuse:
100V/115V: T250 mA L250V
230V: T125 mA L250V
~50/60 H z
max. Power Cons.: 10W
qua dra l GmbH & Co. KG - Am Herren h ä u ser Ba h n h of 2 6 -28 - D-30419 Hannover
On
Off
Out 2
L
R
Out 1
LR
Out 3
R
L
R
L
R
L
R
L
Aux
Tu ner
CD Ph ono L2 L1R2 R 1
Di rect
By pass
40
600
120
R/L 2
MCMMR/L 1
Ph ono S witches
XLR 2
LR
XLR 1
LR
Ph ono
GND
USB
TosLink
SP DI f
Digital In
Link
Out
Handmade in Germany
W ARNI N G :
TO REDUCE THE RISK
OF ELECTRICAL SHOCK
OR FIRE, DO NOT EXPOSE
THIS APPLIANCE TO
MOISTURE OR RAIN.
DO N OT REMO VE CO VER. NO USER
SERVICEABLE PA RTS I NSIDE. REFER
SERVICING T O QUA LIFIED PERSON NEL.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
On
Off
max. Power Consumption: 1,
2kW
Fuse:
100V / 115V:
T6.3 ,
A L250V
230V:
T3.15, A L250V
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
ACHTUNG
STROMSCHLAG GEFAHR
NICHT ÖFFNEN
ATTENTION
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
ATENCIÓN
RIESGO DE DESCARGA ELCTRICA
NO ABRIR
DO NOT REMOVE C OVER. N O USER
-
SERV ICEABLE PAR TS
IN SIDE. REFER SERVICING TO QUALIFIED PERSONN EL.
TO REDUCE THE RISK OF ELECTRICAL SHOCK OR FIRE, DO NOT
EXPOSE THIS APPLIANCE TO MOISTURE OR RAIN.
In Out
Link
Gain
Mono / Stereo
RCA / XLR
+3 / 0
/
-10 dB
quadral GmbH & Co. KG - Am Herrenhäuser Bahnhof 26-28 - D-30419 Hannover
Handmade in Germany
®
AURUM
Balanced In
Right
Left
Mono In
Unbalanced In
Right
Left
Mono In
A
B
Right
+ +
Mono
AB
Left
+ +
Mono+
+
+
XLR Stereo connection
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Quadral Aurum M8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Quadral Aurum M8 in the language / languages: English, German as an attachment in your email.

The manual is 1,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info