815520
17
Zoom out
Zoom in
Previous page
1/28
Next page
17 7094-803D 12/23
B. Cleaning the Glass & Replacement
Mostofthecarbondepositsontheglasswillburno󰀨during
hotres.
However, the ash residue that accumulates on the glass
surface should be removed regularly to prevent etching. To
cleantheglass,followthisprocedure:
Be sure the glass is completely cool.
Clean the glass with water or a cleaner made especially for
this purpose. Do not use abrasive cleaners. Use cleaning
agentssparinglyandbesuretokeepthemo󰀨theouter
surfaces of the stove.
Rinse the glass thoroughly.
Dry the glass completely.
Replace Broken Glass Immediately
Do not operate your stove if the glass in the doors is damaged.
Ifyouneedtoreplacetheglass,useonlythehightemperature
5mmceramicglasssuppliedbyQuadra-Fire.Donotuse
substitutes.
Service Part: SRV7094-054
1. Ensurethatthereisoutandtheapplianceiscooltothe
touch.
2. Protect a table or counter top with padding or towels.
Protect your hands and wear gloves to prevent injury.
3. Removethedoorwiththebrokenglassbyliftingthedoor
upando󰀨ofthehinges.
4. Laydoorfacedownonatableorcountermakingsure
thehandlehangsovertheedgesothedoorlaysat,on
a soft surface.
5. Removethescrewsfromeachglassretainerandremove
the glass. (If screws are di󰀩cult to remove, soak with
penetratingoilrst).
6. Center the glass with edges evenly overlapping the
opening in the door, (i.e. same space top and bottom,
left and right sides).
7. Replace the glass retainers. Be careful not to cross
thread the screws.
8. Tighten each retainer just a few turns until each is
secured. Check again for centering of glass in door
frame. Continue to tighten each retainer alternately, a
few turns at a time, until the glass is secure.
NOTE: DO NOT OVER TIGHTEN RETAINERS - can
causeglasstobreak.
9. Replace the door on the appliance.
Quadra-Fire appliances are equipped with ceramic super
heat-resistant glass, which can only be broken by impact
or misuse.
Injury Risk.
• Useonlyglassspeciedinmanual.
• DONOTREPLACEwithanyothermaterial.
WARNING
Handle glass assembly with care.
When cleaning glass:
Glass
Assembly
CAUTION
• Avoidstriking,scratchingorslammingglass.
• DoNOTcleanglasswhenhot.
• DoNOTuseabrasivecleaners.
• Useahardwaterdepositglasscleaneronwhitelm.
Use commercial oven cleaner on heavier deposits.
Remove all residue of oven cleaner or will permanently
stainglassonnextring.
Refer to maintenance instructions.
C. General Maintenance
1. Creosote (Chimney) Cleaning
• Frequency: Every 2 months during heating season
or as recommended by a certied chimney sweep;
morefrequentlyifchimneyexceedsorisunder14-16
ft. (measured from bottom of appliance)
• By:CertiedChimneySweep
Removeallashfromthereboxandextinguishallhotembers
before disposal. Allow the appliance to cool completely.
Disconnectuepipeorremoveba󰀪eandceramicblanket
fromappliancebeforecleaningchimney.Otherwiseresidue
canpileupontopoftheba󰀪eandceramicblanketandthe
appliancewillnotworkproperly.(SeeBa󰀪e Board on page
19). Close the door tightly. The creosote or soot should be
removedwithabrushspecicallydesignedforthetypeof
chimneyinuse.Cleanoutfallenashesfromtherebox.
It is also recommended that before each heating season
the entire system be professionally inspected, cleaned and
repaired, if necessary.
Inspection - Inspectthesystemattheapplianceconnection
and at the chimney top. Cooler surfaces tend to build
creosote deposits quicker, so it is important to check the
chimney from the top as well as from the bottom.
Formation and Need For Removal - Whenwoodisburned
slowly, it produces tar and other organic vapors which
combine with expelled moisture to form creosote.
The creosote vapors condense in the relatively cool
chimneyue of a newly-started or aslow-burningre.As
a result, creosote residue accumulates on the ue lining.
When ignited, this creosote creates an extremely hot re
which may damage the chimney or even destroy the house.
The chimney connector and chimney should be inspected
once every 2 months during the heating season to determine
if a creosote or soot buildup has occurred. If creosote or
soot has accumulated, it should be removed to reduce the
riskofachimneyre.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Quadra-Fire Expedition I at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Quadra-Fire Expedition I in the language / languages: English as an attachment in your email.

The manual is 5.32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Quadra-Fire Expedition I

Quadra-Fire Expedition I User Manual - French - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info