815524

Quadra-Fire Classic Bay 1200 Pellet Manual

11
Zoom out
Zoom in
Previous page
1/40
Next page
11 7027-802M 04/23
Figure 11.1
Fuel Adjustment
Rod
Thumb
Screw Set Screw
J. Feed Rate Adjustment Instructions
The feed adjustment control rod is factory set, and should
be adequate for most fuels. The set screw is located at the
bottom of the hopper and set loose at the factory so the
fuel adjustment control rod will slide up and down by only
loosening the thumb screw at the top (Figure 11.1). Do not
re-tighten bottom set screw.
However, if the flame height is too high or too low, you will
need to adjust the feed rate. Wait until the appliance has
been burning for 15 minutes before making your adjustments
and allow 15 minutes for feed adjustment to take e󰀨ect.
1. Loosen the thumb screw (Figure 11.1).
2. Adjust the fuel adjustment control rod upwards to
increase the feed rate and ame height or downwards to
decrease the feed rate and ame height.
3. Re-tighten the thumb screw.
3. Occasionally the appliance may run out of fuel and shut
itself down. When this happens, the red call light will be
on (See Figure 10.1 on page 10). To restart it, ll the
hopper and press the reset button (Figure 10.1 on page
10). When you press the reset button the red call light will
go out. Release the button and the light will come back
on. You should see a re shortly. If not, follow Starting
Your First Fire on page 10.
L. Restarting the Appliance
Restart Process
1. When the unit has run out of fuel, add pellet fuel to
the hopper.
2. Dump the ashes and clinkers built up in the re pot by
pulling the ash dump removal handle out several times.
Make sure clinkers have dropped into the ash pan then
return the handle to fully closed position.
3. Press the reset button; the appliance will then being its
startup sequence.
Restarting After a Power Failure
1. For an electrical disruption the appliance will start on
its own without need for priming - providing the control
system is asking for heat.
Hot while in operation. Keep children, clothing and
furniture away. Contact may cause skin burns.
CAUTION
WARNING
Fire Risk
Do NOT operate appliance:
• With appliance door open.
• Fire pot oor open.
• Cleaning slide plates open.
Do NOT store fuel:
• Closer than required clearances to combustibles to
appliance.
• Within space required for loading or ash removal.
K. Ignition Cycles
1. At the beginning of each ignition cycle, it is normal to see
some smoke in the rebox. The smoke will stop once the
re starts.
2. The convection blower will automatically turn on after
your appliance has been burning for approximately 10
minutes. This blower transfers heat from your appliance
into the room, and will continue to run after the thermostat
has stopped calling for heat until the appliance has
cooled down.
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Quadra-Fire Classic Bay 1200 Pellet at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Quadra-Fire Classic Bay 1200 Pellet in the language / languages: English as an attachment in your email.

The manual is 5.89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Quadra-Fire Classic Bay 1200 Pellet

Quadra-Fire Classic Bay 1200 Pellet User Manual - French - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info