815524
9
Zoom out
Zoom in
Previous page
1/40
Next page
97027-802M 04/23
E. Before Your First Fire
1. First, make sure your appliance has been properly
installed and that all safety requirements have been met.
Pay particular attention to the re protection and venting.
2. Double check that the ash drawer and rebox are empty
and the re pot oor is fully closed.
3. Check the position of the thermocouple, located above
the re pot, and make sure that it protrudes approximately
3/4 inch (19mm) into the re pot.
4. Close and latch the door.
F. Filling the Hopper
Open the hopper lid by lifting the handle. Fill the hopper
with fuel. Close the hopper lid. The unit will not feed with the
hopper lid open and the re will go out.
Storage
Wood pellets should be left in their original sealed bag
until using to prevent moisture absorption.
Do not store any pellet fuel within the clearance
requirements or in an area that would hinder routine
cleaning and maintenance.
Size
Pellets are either 1/4 inch or 5/16 inch (6-8mm)
in diameter.
Length should be no more that 1-1/2 inches (38mm).
Pellet lengths can vary from lot to lot from the
same manufacturer.
Due to length variations, the ame height (feed rate) may
need adjusting occasionally.
Performance
Higher ash content requires the ash drawer to be emptied
more frequently.
Hardwoods require more air to burn properly.
Premium wood pellets produce the highest heat output.
Burning pellets longer than 1-1/2 inches (38mm)
can cause an inconsistent fuel feed rate and/or
missed ignitions.
Changing to Di󰀨erent Fuel Type
Empty the hopper of the previous fuel.
Thoroughly vacuum hopper before lling with the
new fuel.
The burn rate, BTU content and heat output will all vary
depending on the fuel selected.
Tested and approved for wood pellet fuel only. Burning of
any other type of fuel voids your warranty.
CAUTION
Tip of thermocouple must be in contact with the inside
end of the thermocouple cover.
Missed ignitions can occur.
CAUTION
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Quadra-Fire Classic Bay 1200 Pellet at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Quadra-Fire Classic Bay 1200 Pellet in the language / languages: English as an attachment in your email.

The manual is 5.89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Quadra-Fire Classic Bay 1200 Pellet

Quadra-Fire Classic Bay 1200 Pellet User Manual - French - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info