815525

Quadra-Fire Classic Bay 1200 - Pellet - Insert Manual

19
Zoom out
Zoom in
Previous page
1/40
Next page
19 04/217027-805J
Clinker
Figure 19.1
Back side of Firepot
Firepot floor left open
Figure 19.2
NOTE: If you are just cleaning the re pot, there is no
need to unplug the insert.
C. General Maintenance and Cleaning
1. Types of Fuel
Type of fuel you are burning will dictate how often you have
to clean your re pot.
If the fuel you are burning has a high dirt or ash content, it
may be necessary to clean the re pot more than once a
day.
Dirty fuel will cause clinkers to form in the re pot
(Figure 19.1). A clinker is formed when dirt, ash or a non-
burnable substance is heated to 2000°F (1093°C) and
becomes glass-like. High Ash Fuel Content Maintenance
on page 23 in this section for more details on fuels with high
ash content.
3. Ash Removal from Firebox
• Frequency: Weekly or more frequently depending on
ash build-up
• By: Homeowner
a. There must not be any hot ashes in the rebox during
cleaning so allow the appliance to completely cool.
Frequent cleaning of the ash in the rebox will help
slow down the build-up of ash in the exhaust blower
and vent system.
b. Plug in your appliance, if unplugged, and turn the
thermostat on and immediately shut it o󰀨 to start the
exhaust blower on its cycle time. It will pull y ash out
the exhaust instead of into the room.
c. Open door. There are 2 cleaning slide plates to the
left and right of the re pot with nger holes. Pull both
slide plates out and sweep the remaining ash from
the rebox into the 2 open holes. A paint brush works
well for this. Close slide plates.
d. This ash is deposited in the same ash drawer as the
re pot debris. The ash drawer should be emptied
every time you clean the rebox. Remember to
place the ash and debris into a metal or non-
combustible container.
e. The 2 cleaning slide plates must be fully closed when
cleaning is complete. See Disposal of Ashes on
page 20.
4. Cleaning Ash Drawer
• Frequency: Weekly or every 5 bags of fuel
• By: Homeowner
Empty into a non-combustible container and re-install ash
drawer (Disposal of Ashes on page 20).
b. Pull re pot cleaning rod OUT and IN a couple of
times to help shake debris loose.
c. If rod is hard to pull, it may be necessary to use your
re pot clean-out tool to chip away material that has
built up on the bottom plate of the re pot and to
push out any clinkers. Larger clinkers may have to be
removed from the top of the re pot.
d. The re pot oor plate must be fully closed when
nished (Figure 19.2).
2. Cleaning Fire pot with Cleaning Rod & Fire pot
Clean-Out Tool
• Frequency: Daily or more often as needed
• By: Homeowner
a. The appliance must be in complete shutdown and
cool and the exhaust blower o󰀨.
Fire Risk.
• NEVER pull re pot cleaning rods or
cleaning slide plates when appliance is
operating. Hot pellets may fall into ash pan
and may start a re or have mis-starts due
to lack of vacuum.
WARNING
Fire Risk
• The cleaning slide plates must be fully
CLOSED when appliance is operating.
Hot pellets may fall into ash pan and start
a re.
WARNING
… 19 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Quadra-Fire Classic Bay 1200 - Pellet - Insert at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Quadra-Fire Classic Bay 1200 - Pellet - Insert in the language / languages: English as an attachment in your email.

The manual is 9.01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Quadra-Fire Classic Bay 1200 - Pellet - Insert

Quadra-Fire Classic Bay 1200 - Pellet - Insert User Manual - French - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info