815522
30
Zoom out
Zoom in
Previous page
1/40
Next page
30 12/237021-802L
Figure 30.1
VACUUM
SWITCH
SNAP
DISC #2
CAPACITOR FEED
MOTOR
SNAP
DISC #1
CONVECTION
BLOWER
COMBUSTION
BLOWER
SNAP
DISC #3
FUSE
RESET
BUTTON
CALL
LIGHT
THERMOS TAT
BLOCK
HEAT OUTPUT
SWITCH
THERMOCOUPLE
IGNITOR
YELLOW
YELLOW
RED
RED
ORANGE
WHITE
BLUE
BLUE
PURPLE
GR AY
BLACK
BLACK
BLACK
BLACK
HOPPER
SWITCH
20. Vacuum Switch: The vacuum switch is located on the
lower right side of the appliance behind right side panel.
This switch turns the feed system on when vacuum is
present in the rebox. The vacuum switch is a safety
device to shut off the feed motor if the exhaust or the
heat exchanger system is dirty or plugged or if the
rebox door is open.
21. Wiring Harness: See Figure 30.1 below.
17. Snap Disc #1 (Convection Blower) 110°F: Snap disc
#1 is located on the right side of the appliance on the
bottom of the heat exchanger box. There are 2 purple
wires connected to it. This snap disc turns the convection
blower on and off as needed. Power is always present
at snap disc #1.
18. Snap Disc #2 (Fuel Delivery Interrupt) 250°F: Snap
disc #2 is also located on the back side of the feed drop
tube. There are 2 orange wires connected to it. This
snap disc will turn off the feed system which will turn
off the appliance if an over re condition should occur
or if the convection blower should fail to operate. If this
occurs the snap disc will automatically reset itself.
19. Snap Disc #3 (Back Burn Protector) 250°F: Snap
disc #3 is mounted on the back of the auger tube in
the center of the appliance and has a reset button. To
access it remove the right side panel. If the re tries to
burn back into the feed system or push exhaust up the
feed tube, this snap disc will shut the entire system off.
This disc must be manually reset.
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Quadra-Fire Castile - Pellet at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Quadra-Fire Castile - Pellet in the language / languages: English as an attachment in your email.

The manual is 8.11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Quadra-Fire Castile - Pellet

Quadra-Fire Castile - Pellet User Manual - French - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info