815512
22
Zoom out
Zoom in
Previous page
1/40
Next page
22 05/237037-802H
Magnet
Spade
Connectors
Snap Disc
Figure 22.1
B. Snap Disc
Service Part: SRV230-0470
Locate the snap disc bracket assembly at the bottom left
rear corner of the appliance.
A magnet holds the bracket to the appliance. Pull the
bracket down away from the appliance to expose the snap
disc.
Using a Phillips head screw driver, remove the 2 screws
from the snap disc and then remove the snap disc from
the spade connectors.
Replace with new snap disc and re-connect to
spade connectors.
Pull the snap disc and spade connectors up and out of
bracket as shown in Figure 22.1
Push the snap disc and spade connectors back inside
bracket and re-attach the bracket to the appliance.
A. Glass
NOTE: Replace with 5mm ceramic glass only.
Service Part: 7000-012
1. Ensure that the re is out and the appliance is cool to the
touch.
2. Protect a table or counter top with padding or towels.
Protect your hands and wear gloves to prevent injury.
3. Remove the door with the broken glass by lifting the door
up and off of the hinges.
4. Lay door face down on a table or counter making sure the
handle hangs over the edge so the door lays at, on a soft
surface.
5. Remove the screws from each glass retainer and remove
the glass. (If screws are difcult to remove, soak with
penetrating oil rst).
6. Center the glass with edges evenly overlapping the
opening in the door, (i.e. same space top and bottom,
left and right sides).
7. Replace the glass retainers. Be careful not to cross
thread the screws.
8. Tighten each retainer just a few turns until each is
secured. Check again for centering of glass in door
frame. Continue to tighten each retainer alternately, a
few turns at a time, until the glass is secure.
NOTE: DO NOT OVER TIGHTEN RETAINERS - can
cause glass to break.
55 Service Parts Replacement
9. Replace the door on the appliance.
Quadra-Fire appliances are equipped with ceramic super
heat-resistant glass, which can only be broken by impact
or misuse.
Handle glass assembly with care.
When cleaning glass:
Glass
Assembly
Avoid striking, scratching or slamming glass.
Do NOT clean glass when hot.
Do NOT use abrasive cleaners.
Use a hard water deposit glass cleaner on white lm.
Use commercial oven cleaner on heavier deposits.
Remove all residue of oven cleaner or will permanently
stain glass on next ring.
Refer to maintenance instructions.
CAUTION
Injury Risk.
Use only glass specied in manual.
DO NOT REPLACE with any other material.
WARNING
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Quadra-Fire 4300 Step Top at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Quadra-Fire 4300 Step Top in the language / languages: English as an attachment in your email.

The manual is 6.73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Quadra-Fire 4300 Step Top

Quadra-Fire 4300 Step Top User Manual - French - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info