Note: During an application, you can switch between the two rotation directions of the massage heads 5 and switch the heating function on and off according to your personal
preference.
The integrated automatic switch-off automatically switches the product off after the maximum operating time of 15 minutes. This is not a malfunction. After the automatic switch-
off, you can immediately switch the product on again and use it (e.g. for massages on other body areas, other people). However, make sure not to exceed the maximum usage time
of 15 minutes per body zone.
You operate the product with the control panel 7 (see fig. A).
Press the on/off button 9 once to switch on the product. The signal light above the on/off button 9 lights up red, indicating that the product is switched on.
To switch the product off, press the power button 9 again. The red signal light above the power button 9 turns off, indicating that the product is switched off.
To start the massage function, press the 10 button once or the 11 button once when the product is on. The signal light above the corresponding button lights up green,
indicating that the massage heads 5 rotate in the corresponding direction 10 Change of direction: the massage heads 5 rotate in the opposite direction.
11 Direction change button: The massage heads 5 rotate in the opposite direction.
To switch on the heating function, press the heating button 6 when the product is switched on. The signal light above the heating button 6 lights up red to indicate that the heating
function is on.
To switch off the heating function, press heating button 6 again. The red signal light above the heating button 6 goes out, indicating that the heating function has been switched off.
Using the product without the top
Improper use of the product may result in damage to the product.
Do not use the product sitting down. Never lie or sit on the product. the product.
Open the zip 2 completely (see fig. C).
Remove the upper part 13 upwards from the lower part 8.
Plug the appliance plug 4 into the socket 3.
Plug the mains adapter 12 into a socket to establish the mains connection for the product.
Place the lower part 8 with the massage heads 5 on the body parts such as the shoulders or back and then gently lean against the backrest of the chair (see fig. B). The lower part 8
is now between your body and the backrest of the chair. Take care not to lean too hard against the base 8 during use to avoid overloading the product.
Switch the product on at control unit 7 and operate it during use with control unit 7 (see section “Operating the product with the control unit”).
Switch the product off at control unit 7 to cancel the massage in progress. Or:
Use the product for a maximum of 15 minutes.
After 15 minutes of use, the product switches off automatically (automatic switch-off). Unplug the mains adapter 12 to disconnect the product from the mains.
Unplug the appliance 4 from the socket 3 .
CLEANING CARE AND STORAGE
Ensure that no water or other liquids get into the interior of the product, the control panel or the power supply unit.
7 or the plug-in power supply unit 12
Unplug mains adapter 12 from the mains outlet before cleaning.
Let the product cool down completely.
Do not clean the product in the dishwasher.
Do not use aggressive detergents or hard brushes!
Do not bleach.
Do not use bleaching agents (such as heavy-duty detergents).
Do not tumble dry.
Do not iron.
Do not dry clean.
Soft wash programme 30 °C
Open the zip 2 completely and remove the top part 13 from the bottom part 8 (see fig. C).
Clean the bottom part 8 and the control part 7 with a slightly damp cloth and water.
For heavier soiling, you can also use a light soap solution. However, always ensure that the cloth is only slightly damp to prevent moisture from penetrating the product or the
control panel 7.
Clean the top 13 by washing it by hand or in the washing machine (gently at 30 °C).
Allow the top 13 to dry completely.
After cleaning, reassemble the top 13 and bottom 8 and close the zip 2 .
Protect the product from direct sunlight.
Do not place objects or anything similar on the product.
Store the product out of the reach of children, tightly closed and at a storage temperature between 5 and 20 °C (room temperature). room temperature).
Store the device and all parts in the original packaging in a dry environment if you are not going to use it for a long time.
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for QLT HAC22043 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of QLT HAC22043 in the language / languages: English, German, Dutch, French as an attachment in your email.
The manual is 1.71 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
