572629
14
Zoom out
Zoom in
Previous page
1/38
Next page
TROUBLESHOOTING
Listed below are some potential problems that may occur when using the
Sentinel G2+. Carry out the recommended checks and troubleshooting
steps in the order listed. Please note that the table does not list all of the
possible problems. If the problem experienced with the scope is not
mentioned, or if the suggested action meant to correct it does not resolve
the problem, please contact the manufacturer.
 
Электронно-оптический преобразователь (ЭОП) поколения 2+
Прицельная дальномерная метка с возможностью выбора цвета
(зеленый/красный) или метка Mil-Dot*
Класс герметичности IPX4 (влагозащищенный)
Высокое разрешение и качество изображения по всему полю
экрана ЭОП
Высококачественная светосильная оптика с оптимальным
увеличением 3 и 4 крата
Минимальная дистанция наблюдения 5 метров.
Выбор креплений, позволяющих установить прицел практически
на любой тип охотничьего оружия
Автономный блок питания со стабилизацией напряжения
Вертикальное расположение батареи надежность энергоснаб-
жения при стрельбе
Эргономичный дизайн
Фокусируемый ИК-осветитель
Дистанционный пульт управления с разъемом повышенной
надежности
Дополнительная боковая планка Weaver
Нетеряющаяся крышка объектива
Легкий и прочный титановый корпус
* В моделях 76125T и 76126T.

Мы настоятельно рекомендуем Вам внимательно изучить
инструкцию прежде, чем включить прицел.
Прицел ночного видения "Sentinel G2+" предназначен для
наблюдения и ведения прицельной стрельбы в сумеречное и ночное
вре мя. В п рицеле уста новлен элек тро нно-о пти ческий
преобразователь поколения 2+, прибор имеет фокусируемый
12
61
Possible cause(s) Corrective action
Problem
The riflescope
does not turn on.
The riflescope turns off
as the IR is turned on.
The red reticle is blurred
and can not be focused
with the eyepiece.
With a crisp reticle image,
the image of the target
at least 30m away
is blurred.
Distinct black dots or
specks on the screen
while the image
is focused.
The batteries have
been installed incorrectly.
Oxidized contact points in the
battery compartment due to “leaky”
batteries or contact points becoming
exposed to a chemically reactive
solution.
Total battery power is too low.
The eyepiece is not adjusted
correctly.
Dust and moisture are covering
the outside optical surfaces.
Condensation collects on the
inside of the objective and the
eyepiece lenses, or is on the
optical surfaces of the electronic-
optical converter, and may be
caused by the scope fogging due
to a rapid change in temperature.
Total battery charge is less
than 2.0V.
Luminance level in the observation
area is too high.
The dots are cosmetic blemishes
resulting from IIT production
processes and do not interfere with
the reliability or performance of the
scope; the size of the dots are
specified in the technical
requirements for IIT's and the
scope itself.
Reinstall the batteries
with the correct polarity orientation.
Clean the battery compartment,
focusing on the contact points.
Install fresh batteries.
Adjust the eyepiece according to the
instructions in the “Operating
the Sentinel G2+” section.
Clean the lens surfaces with a soft
cotton tissue or cloth.
Let the unit dry by leaving it
in a warm environment
for 4 hours.
Install fresh batteries.
Slide the protective cap
(with a pinhole) on the objective lens
or enter a dark environment.
No need to take corrective action
or return the scope.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pulsar Sentinel G2 plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pulsar Sentinel G2 plus in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 2,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info