Manual Provision ISR NVR-4100 (page 31 of 73) (English)

634707

Zoom out

Zoom in

1/73

5.5.2 Motion Alarm

Motion includes two sub menus: motion and schedule. The steps to set motion alarm are as follows:

Step 1: Enter into MenuSetupAlarm MotionMotion tab. Refer to Fig 5-19:

Step 2: Enable motion alarm, set alarm hold time which refers to the time till which the system will wait for

further detection of motion. e.g. If the holding time is set to 10 seconds, once the system detects a motion,

it will go into alarm but would not detect any other motion alarm (specific to channel) until 10 seconds. If

there is other motion detected during this period it is considered it as continuous movement, otherwise it

will be considered as a single motion.

Fig 5-19 Alarm Configuration-Motion

Step 3: The setup steps of motion trigger are similar to “Alarm Handling” (See Chapter 5.5.1 Sensor

Alarm Handling setting for more details).

Step 4: After clicking Area button, a dialog box will pop up as Fig 5-20:

Fig 5-20 Motion-Area

Step 5: In the Area interface, you can drag slide bar to set the sensitivity value (1-8). The higher the value is

the more sensitive it is to motion. Since the sensitivity is influenced by color and time (day or night), you

can adjust its value according to the practical conditions. Left click the grid and drag to delete area. Click

icon to set the whole area as detection area. Click icon to clear the set detection area. Click

icon to test the sensitivity as per the local conditions. Once motion is sensed, it displays a figure icon.

Click icon, to save the setting. Click icon to exit the current interface.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Provision ISR NVR-4100 in the language / languages: English as an attachment in your email.

The manual is 4,65 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Provision ISR NVR-4100 Manual

Product: