527006

Proosten GBC 100 Klein Manual

11
Zoom out
Zoom in
Previous page
1/22
Next page
4. Connection
Connect a red wire on the + bolt of the charger by means of an M6 cable eye.
Repeat this with a black wire on the - bolt of the charger. Fasten the other side of
the red cable on the + pole of the battery (with an alligator clip or battery clamp).
Repeat this with the black wire on the - pole of the battery.
After the battery has been connected to the charger the power plug can be put into
a socket outlet and the charger can be switched on. The charging process will
begin.
When you want to disconnect the charger from the battery, the charger must be
switched off firstly and the power plug must be removed from the outlet.
Important
The battery junction that isn’t linked with the frame should be connected
firstly. The other junction must be made with the frame.
The connection between the charger and the battery must be made some
distance from the fuel installation.
Check whether the mains voltage of the voltage source is the same as the
required voltage of the charger
Damaged wires/cables should be replaced immediately
It is also very important that you observe the following procedures:
always use the screw nuts and washers (brass nickel) included. When other
materials are used there is a risk that the bolt will burn out of the print board.
make sure that the wires make good contact between the charger and the
battery. If this connection is weak, there is a chance that the bolts will burn out of
the print board.
do not tighten the screws more than necessary. If the screws are tightened too
much the bolts may disconnect from the print board.
If the charger has a malfunction because these procedures are not observed, the
warranty will lapse.
Tip
It is advisable to mount a fuse between the + pole of the battery and the + bolt of
the charger. Always use a fuse that is heavier than the charge current.
11
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Proosten GBC 100 Klein at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Proosten GBC 100 Klein in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 0,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info