654279

Proline PLCD 330 WD SS Manual

32
Zoom out
Zoom in
Previous page
1/64
Next page
BEFORE PLACING FOOD IN THE APPLIANCE
x Remove all packaging.
x Allow the appliance to run empty for 2 – 3 hours so the compartments can cool to the appropriate
temperature.
x Clean the inside of the appliance with warm water and a little liquid detergent to remove
manufacturing and transportation dust.
POWER FAILURE
If there is a power failure, do not open the door. Frozen food should not be affected if the power failure
lasts for less than  hours.
Do not refreeze frozen foods that have thawed completely. The food may be dangerous to eat.
TEMPERATURE CONTROL
The appliance is controlled with a temperature control knob located inside the appliance.
Adjust the control knob as desired to suit your individual preference.
0 is off setting
1 is warmest setting
7 is coldest setting
In the 0 position the appliance does not operate (the cooling system is switched off), but power supply is
not interrupted.
The running time and temperature are affected by where the appliance is located, how often the doors
are opened and the temperature of the room the appliance is located in.
When you use the appliance for the first time or after defrosting, adjust the control knob to the coldest
setting for at least 2 hours before introducing food to be stored, and then readjust to the middle setting.
MOVING YOUR APPLIANCE
If the appliance is turned off for any reason, wait for 10 minutes before turning it back on. This will allow
the refrigeration system pressures to equalise before restarting.
x Turn off the appliance and unplug it from the mains socket. Remove all food. Also remove all mobile
parts (shelves, accessories, etc.) or fix them into the appliance to avoid any shock.
x Relocate and install. If the appliance has been left on its side for any length of time, leave it standing
upright for at least 10 minutes before turning on.
Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an environmentally friendly
and natural gas, it is explosive. Therefore you should be careful during shipment and installation to
prevent your appliance’s cooler elements from being damaged. In the event of a leak caused by damage
to the cooler elements, move your appliance from open flame or heat sources and ventilate the room
where the appliance is located for a few minutes.
Downloaded from www.vandenborre.be
… 32 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Proline PLCD 330 WD SS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Proline PLCD 330 WD SS in the language / languages: English, Dutch, French as an attachment in your email.

The manual is 1,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info