453383

Proline PLC 235 Manual

56
Zoom out
Zoom in
Previous page
1/64
Next page
Downloaded from www.vandenborre.be
IMPORTANT INFORMATION:
This appliance is designed to operate in ambient temperatures (surrounding air temperature)
between 16 and 32
o
C If these temperatures are exceeded i.e., colder or warmer, the appliance
will not operate correctly. Should the ambient temperatures be exceeded for long periods, the
temperature in the freezer section will rise above -18 and food spoilage may occur.
Remove all packaging materials from the appliance. Wash the inside of the cabinet with
lukewarm water and bicarbonate of soda (5ml to 0.5 litre of water). Dry the appliance thoroughly.
When using the freezer for the first time or after defrosting, turn the thermostat control to the
maximum position for at least 2 hours before introducing food to be stored, and then readjust to
the normal position.
If there is a power failure, do not open the door. Frozen food should not be affected if the failure
lasts for less than 12 hrs. If the failure is longer, then the food should be checked and either
eaten immediately or cooked and then re-frozen.
DISPOSAL:
As old refrigeration appliances may contain CFC's which will damage the ozone layer,
when disposing of any refrigeration appliance please contact your local waste disposal
department for advice on the correct method of disposal.
The refrigerating gas contained in the circuit of this appliance is Isobutene (R600a);
it causes a low level of pollution but is inflammable.
Please contact your local disposal
department for advice on the correct method of disposal.
INSTALLATION:
This appliance must be position on a flat stable surface; any unevenness can be rectified by adjusting
the two front feet by screwing them in or out.
Do not position this appliance in an excessively cold our damp areas such as a garage or cellar
etc.
Do not locate your freezer near a heat source, EG cooker, boiler or radiator. Also avoid direct
sunlight.
Position the appliance and allow to stand for two to three hours before it is turned on
for the first time to allow the system to settle.
A clearance of 10 cm must be left between the sides of the appliance and any
adjacent cabinets or walls to allow for adequate air circulation. The appliance is not
designed for recessed installation (“building in”).
NOTE: If the appliance is positioned on a carpet, soft floor covering you should
readjust the front feet once the appliance has had time to settle.
This appliance is supplied with two wall spacers that must be installed be inserting them into the two
holes in the appliance top at the back of the unit, by turning them in a 45
o
direction.
This is to prevent the appliance being pushed to close to the wall.
… 56 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Proline PLC 235 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Proline PLC 235 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 0,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info