654268
22
Zoom out
Zoom in
Previous page
1/65
Next page
GB
23
INSTALLATION
Unpacking
All transit bolts at the rear of the appliance and packing must be
removed before using the appliance.
Keep all packaging away from children.
Keep all the transit bolts for re-use in case the appliance is to be
transported again.
Positioning
Install the appliance on a flat hard floor.
Make sure that there is sufficient space for air circulation around the appliance.
Do not install the appliance on the carpet floor.
Levelling
Level the appliance by raising or lowering the feet.
Loosen the lock nut using a spanner (not supplied) and turn the foot by
hand until it contacts the floor.
Hold the foot with one hand and fasten the nut against the cabinet
with a spanner.
Accurate levelling prevents vibration, noise and displacement of the
appliance during operation.
Water inlet
Screw one end of the inlet hose on the back of the appliance.
The appliance must be connected to a cold water supply.
Connect the other end of the inlet hose to a tap with a 3/4” thread.
Water drainage
To plumb in the appliance, please use one of the following methods.
1.Push the hose firmly into a drainage standpipe.
OR
2. Connect the drain hose onto a sink outlet spigot securely.
Min.60cm
Max.100cm
Notes:
Make sure that the water discharge hose does not bend, buckle, is not crushed or extended.
The water drain hose should be mounted at a height of minimum 60 cm, maximum 100 cm from
the ground.
Never put cartons, wooden blocks or similar materials under
the machine to balance the irregularities on the level of the
ground.
Electrical connection
Your washing machine works with 220240V and 50Hz.
Electrical connections must be carried out by a qualified technician in
compliance with the current safety regulations.
Your washing machine must be properly earthed. We will not be held
responsible for any damage that may occur as a result of usage without
correct earth connection.Do not use extension leads or multisockets.
Downloaded from www.vandenborre.be
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Proline PFL 106F at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Proline PFL 106F in the language / languages: English, Dutch, French, Spanish as an attachment in your email.

The manual is 5,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info