654311
5
Zoom out
Zoom in
Previous page
1/80
Next page
EN - 4 -
Before installing and operating your appliance
Before starting to use your fridge, you should pay attention to the following points:
• Operating voltage for your fridge is 220-240 V at 50Hz.
• The plug must be accessible after installation.
• Yourappliancemayhaveasmellwhenitisoperatedforthersttime;thesmellwillfade
away when your appliance starts to cool.
• Before making the connection to the power supply, ensure that the voltage on the rating
label corresponds to the voltage of electrical system in your home.
• Inserttheplugintoasocketwithanefcientgroundconnection.Ifthesockethasno
ground contact or the plug does not match, please call an authorised electrician for
assistance.
• The appliance must be connected with a properly installed fused socket. Power supply
(AC) and voltage at the operating point must correspond to the details stated on the
rating label of the appliance (located on the inside left of the appliance).
• We do not take responsibility for damages that may occur as a result of usage without
grounding.
• Place your fridge in a place where it is not exposed to direct sunlight.
• Your fridge should never be used outdoors or left under the rain.
• Your appliance should be at least 50 cm away from stoves, gas ovens and heater cores,
and should be at least 5 cm away from electrical ovens.
• Do not place heavy items on the appliance.
• Clean the appliance thoroughly, especially in the interior, before use (See Cleaning and
Maintenance).
• The installation procedure into the kitchen unit is given in the Installation Manual. This
product is intended to be used in proper kitchen units only.
• The adjustable front legs should be adjusted to an appropriate height to allow your
appliance to operate in a stable and proper way. You can adjust the legs by turning
them clockwise (or counter-clockwise). This should be done before placing food in the
appliance.
• Before using your fridge, wipe all parts with warm water and one
teaspoon of sodium bicarbonate, and then rinse with clean water
and dry. Place all parts after cleaning.
• Install the distance adjustment spacer (the part with white vanes
attherear)byturningit90°asshownintheguretopreventthe
condenser from touching the wall.
Note:
• Whenitisoperatedforthersttimeoraftertransportation,keepyourfridgeintheupright
position for 3 hours before you plug it in. Otherwise, you may damage the compressor.
Downloaded from www.vandenborre.be
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Proline PCI223-F1-LED at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Proline PCI223-F1-LED in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info