126121
8
Zoom out
Zoom in
Previous page
1/42
Next page
7
Service Manual
Model :DWF1250P/DWP5012WA/DWP4912W/DWP4915SL
Issue
Rev.
4. Installation
4-1.Positioning the appliance
Positioning the appliance in the desired location. The back should rest against the wall behind it,
and ts, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and
drain hoses that can be positioned to the right or the left to facilitate proper installation.
4-2.Leveling the appliance
Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust the
dishwasher,making it level. In any case, the appliance should not be inclined more than 2°. If the
appliance is level, it will help ensure proper performance.
4-3.Cold water connection
Connect the water supply hose to a threaded 3/4 (gas) connector,
making sure that it is fastened tightly in place (DWF1250P/DWP5012WA/
DWP4912W see fig.A).
Some models are fitted with an "Aquastop" water supply hose
(DWP4915SL see fig.B) in which the small filter is already housed
in the threaded end.
If the water pipes are new or have not been used for an extended
period of time, let the water run to make sure that the water is
clear and free of impurities. If this precaution is not taken, there
is a risk that the water inlet can get blocked and damage the
appliance.
4-4.Anti-Flooding protection
The dishwasher is equipped with a system that stops the supply of water in the event of a problem
with the water supply hose or leaks within the unit, in order to prevent damage to your home. If for
any reason the box containing the electrical components happens to get damaged, turn off the
power supply and unplug the appliance immediately. In order to guarantee that the anti-flooding
feature operates properly, box "A" with the water supply hose must be attached to the water
supply tap as shown in Fig. B. If the length of the hose is not adequate to make a proper
connection, the hose must be replaced with one which is long enough. This hose is available
upon request from specialised retailers and approved service centres.
4-5.Drain hose connection
Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the sink,
making sure to avoid bending or crimping it. If necessary, fit a syphon trap (U-bend) with a
connecting piece for the drain hose (fig.C). The free end of the hose must be at a height between
40 and 100 cm and must not be immersed in water.
Warning:
The appliance is to be connected to the mains water using new hose sets. Old hose
sets should not be reused.
fig.A
fig.B
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Proline dwp 4915 sl at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Proline dwp 4915 sl in the language / languages: English as an attachment in your email.

The manual is 2,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info