Manual Progress PDB9130 (page 8 of 40) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish)

561431

Zoom out

Zoom in

1/40

EN - Instruction on mounting and use

Closely follow the instructions set out in this manual. All responsibility,

for any eventual inconveniences, damages or fires caused by not complying

with the instructions in this manual, is declined. The extractor hood has been

designed exclusively for domestic use.

Caution

WARNING! Do not connect the appliance to the mains until the installation is

fully complete.

Before any cleaning or maintenance operation, disconnect hood from the

mains by removing the plug or disconnecting the mains electrical supply.

Always wear work gloves for all installation and maintenance operations.

The appliance is not intended for use by children or persons with impaired

physical, sensorial or mental faculties, or if lacking in experience or

knowledge, unless they are under supervision or have been trained in the

use of the appliance by a person responsible for their safety.

This appliance is designed to be operated by adults, children should be

monitored to ensure that they do not play with the appliance.

This appliance is designed to be operated by adults. Children should not be

allowed to tamper with the controls or play with the appliance.

Never use the hood without effectively mounted grating!

The hood must NEVER be used as a support surface unless specifically

indicated.

The premises where the appliance is installed must be sufficiently ventilated,

when the kitchen hood is used together with other gas combustion devices

or other fuels.

The ducting system for this appliance must not be connected to any existing

ventilation system which is being used for any other purpose such as

discharging exhaust fumes from appliances burning gas or other fuels.

The flaming of foods beneath the hood itself is severely prohibited.

The use of exposed flames is detrimental to the filters and may cause a fire

risk, and must therefore be avoided in all circumstances.

Any frying must be done with care in order to make sure that the oil does not

overheat and ignite.

Accessible parts of the hood may became hot when used with cooking

applicance.

With regards to the technical and safety measures to be adopted for fume

discharging it is important to closely follow the regulations provided by the

authorised authorities.

The hood must be regularly cleaned on both the inside and outside (AT

LEAST ONCE A MONTH).

This must be completed in accordance with the maintenance instructions

provided in this manual). Failure to follow the instructions provided in this

user guide regarding the cleaning of the hood and filters will lead to the risk

of fires.

Do not use or leave the hood without the lamp correctly mounted due to the

possible risk of electric shocks.

We will not accept any responsibility for any faults, damage or fires caused

to the appliance as a result of the non-observance of the instructions

included in this manual.

This appliance is marked according to the European directive 2002/96/EC on

Waste Electrical and Electronic Equipment (WEEE). By ensuring this product

is disposed of correctly, you will help prevent potential negative

consequences for the environment and human health, which could otherwise

be caused by inappropriate waste handling of this product.

The symbol

on the product, or on the documents accompanying the

product, indicates that this appliance may not be treated as household

waste. Instead it should be taken to the appropriate collection point for the

recycling of electrical and electronic equipment. Disposal must be carried out

in accordance with local environmental regulations for waste disposal.

Use

The hood is designed to be used either for exhausting

or filter version

Installation

The minimum distance between the supporting surface for the cooking

equipment on the hob and the lowest part of the range hood must be not

less than 50cm from electric cookers and 65cm from gas or mixed cookers.

If the instructions for installation for the gas hob specify a greater distance,

this must be adhered to.

The mains power supply must correspond to the rating indicated on the plate

situated inside the hood. If provided with a plug connect the hood to a socket

in compliance with current regulations and positioned in an accessible area,

after installation. If it not fitted with a plug (direct mains connection) or if the

plug is not located in an accessible area, after installation, apply a double

pole switch in accordance with standards which assures the complete

disconnection of the mains under conditions relating to over-current category

III, in accordance with installation instructions.

Warning! Before re-connecting the hood circuit to the mains supply and

checking the efficient function, always check that the mains cable is correctly

assembled.

Operation

The hood is fitted with a control panel with aspiration speed selection control

and a light switch to control cooking area lights.

Use the high suction speed in cases of concentrated kitchen vapours. It is

recommended that the cooker hood suction is switched on for 5 minutes

prior to cooking and to leave in operation during cooking and for another 15

minutes approximately after terminating cooking.

Maintenance

ATTENTION! Before performing any maintenance operation, isolate the

hood from the electrical supply by switching off at the connector and

removing the connector fuse.

Or if the appliance has been connected through a plug and socket, then the

plug must be removed from the socket.

The cooker hood should be cleaned regularly (at least with the same

frequency with which you carry out maintenance of the fat filters) internally

and externally. Clean using the cloth dampened with neutral liquid

detergent. Do not use abrasive products. DO NOT USE ALCOHOL!

WARNING: Failure to carry out the basic cleaning recommendations of the

cooker hood and replacement of the filters may cause fire risks.

Therefore, we recommend oserving these instructions.

The manufacturer declines all responsibility for any damage to the motor or

any fire damage linked to inappropriate maintenance or failure to observe

the above safety recommendations.

Grease filter - Fig. 1-17

The grease filter must be cleaned once a month using non aggressive

detergents, either by hand or in the dishwasher, which must be set to a low

temperature and a short cycle. When washed in a dishwasher, the grease

filter may discolour slightly, but this does not affect its filtering capacity.

Charcoal filter (filter version only) - Fig. 16

Type 20 LONG LIFE - Washable activated charcoal filter

The charcoal filter can be washed once every two months using hot water

and a suitable detergent, or in a dishwasher at 65°C (if the dishwasher is

used, select the full cycle function and leave dishes out).

Eliminate excess water without damaging the filter, then remove the

mattress located inside the plastic frame and put it in the oven for 10 minutes

at 100° C to dry completely. Replace the mattress every 3 years and when

the cloth is damaged.

Type 15 - NON-washable activated charcoal filter

The saturation of the activated charcoal occurs after more or less prolonged

use, depending on the type of cooking and the regularity of cleaning of the

grease filter. In any case it is necessary to replace the cartridge at least

every four mounths. The carbon filter may NOT be washed or regenerated.

Replacing lamps - Fig. 18

Disconnect the hood from the electricity.

Warning! Prior to touching the light bulbs ensure they are cooled down.

Replace with a new 12 Volt, 20 Watt (Maximum) halogen light made for a G-

4 base SUITABLE FOR USE IN OPEN LUMINAIRES. Follow package

directions and do not touch new light with bare hands.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Progress PDB9130 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 3,62 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Progress PDB9130 Manual

Product: