13
Cleaning
As required, wipe the housing and the paper
filter compartment with a damp cloth. Do not
use any scourers or any solvents. Occasionally
vacuum the floor nozzle and brushheads with
the crevice nozzle.
Paper filter
Progress P60
Carrying and Storage
To make the appliance easier to store and
carry, slide the floor nozzle into the tool rail.
Parking System
For storing the suction pipe and nozzle during
short pauses in vacuuming. The bracket on the
nozzle is slid into the parking rail on the
appliance.
What do I do, if ...
... it is difficult to push the nozzle
Reduce the power setting on the appliance.
This will not reduce cleaning efficiency.
... the motor thermal cut-out is activated
If the motor is overloaded, e.g. due to a full
filter bag or blocked accessory, the thermal
cut-out shuts down the motor. In this case,
switch off the appliance, unplug from the
mains, and leave the motor to cool down.
Check paper filter bag, suction tube and
suction hose; remove any blockage.
The appliance can be switched on again after
approximately 30 minutes.
... the fuse has blown
The fuse may blow if you use other electrical
appliances with high power consumption on
the same electric circuit at the same time as
the vacuum cleaner is in use.
This can be avoided if you set the electronic
power adjuster to the lowest power level and
then select a higher level after switching the
appliance on.
Your vacuum cleaner can be fitted with a gentle
startup control which reduces the starting
current to the motor and therefore prevents the
electric circuit cut-out being triggered under
normal conditions. It is possible that there will
be a delay of about 4 seconds in the appliance
starting up on the lowest power level.
... the paper filter is damaged at some point
and the motor protection filter becomes
dirty Remove motor protection filter, clean
(shake out) and replace.
Insert new paper filter.
