685698
47
Zoom out
Zoom in
Previous page
1/64
Next page
47
PC-GG1179_IM 20.11.18
Gas Connection
General Information
The barbecue can be operated with gas cylinders weighing between 5 kg
and 11 kg. Low pressure butane, propane and LPG gas mixtures are
approved.
Your barbecue works best with propane gas and LPG mixtures. Butane
can be used, on account of the power rating of the appliance, the gas
cylinder may however freeze. As a result of this, the gas pressure drops
and your barbecue does not provide full power.
Use a regulator which is certied in accordance with DIN EN 16129.
NOTE:
For information concerning the correct regulator for gas cylinders,
please consult your LPG dealer.
Regulator and Hose
These parts are supplied with the barbecue. You can obtain spare parts
from your dealer or an approved LPG supplier. Only use hoses and regu-
lators at the pressure stated above which are approved for LPG.
Normally, the service life of a regulator is 2 years. It is recommended that
the regulator is replaced within 2 years of the production date.
WARNING:
The hose that is used must correspond to statutory regulations.
The use of unsuitable hoses and incorrect regulators is dangerous.
Before operation, make sure that you use the correct parts.
Connecting the Gas Cylinder
A connection is established via a exible hose and the correct low pres-
sure regulator. The low pressure regulator should be tted onto the gas
cylinder.
1. Remove the protective cap and the thread protector on the gas
cylinder.
2. Select a suitable wrench and tighten the coupling nut (attention: left
thread) of the low pressure regulator on the gas cylinder hand-tight.
3. Select a suitable wrench and tighten the coupling nut (attention: left
thread) of the hose on the low pressure regulator hand-tight.
Connecting the Appliance
Spider’s webs and insects can block the burner or pipe. Before connect-
ing, make sure that the burner and the burner ports are clean.
You will nd the gas connection on the left hand side of the appliance level
with the adjustment knobs.
Select a suitable wrench and tighten the coupling nut (attention: left
thread) of the hose on the barbecue.
The screw connections of the hose must be securely connected to the
appliance and the low pressure regulator.
Finding Areas with a Bad Seal
CAUTION: Before use, check to make sure there are no areas
with a bad seal.
Never look for sections with a bad seal using a naked ame.
Use a leak detection spray or soapy water.
Sections with a bad seal soon become apparent in soapy water. You will
need approx. 50 ml (mix ratio 1:3).
1. Make sure that all adjustment knobs are in the 12 o’clock position
(OFF).
2. Once you have connected all components as described above, turn
the gas on.
3. Spread the soapy water on the hose and all connections. If bubbles
appear at a particular point, the section has a bad seal and it must be
repaired before use.
4. Repeat the test after the repair.
5. After the test, shut the valve on the gas cylinder.
If you nd a section with a bad seal that you cannot repair, refer the prob-
lem to a gas technician.
Operating the Gas Barbecue
CAUTION: If the hood is closed, only barbecue at a low setting!
NOTE: When using for the rst time
Before preparing food for the rst time:
Close the lid and let the gas burn at a LOW setting for 15 minutes.
The smells from the treated surface are eliminated by the high temperature.
47


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ProfiCook GG 1179 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ProfiCook GG 1179 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 9,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info