814733

ProfiCook EWB 1253 Manual

9
Zoom out
Zoom in
Previous page
1/46
Next page
PC-EWB1253_IM 31.08.22
9
Warnings for the Use of the Appliance
WARNING:
The refrigerant circuit of the appliance uses the refrig-
erant isobutane (R600a), a ammable natural gas with
high environmental sustainability. When transporting and
installing the appliance, prevent the appliance from falling
down. The refrigerant circuit must not get damaged.
CAUTION:
Please observe a waiting period of 2 hours before initial
operation and after moving the appliance for the refriger-
ant to settle. Otherwise the compressor can be damaged.
If the Refrigerant Circuit is Damaged
• Open ames and ignition sources must be avoided.
• Disconnect the mains plug.
• Ventilate the room in which the appliance is installed.
Notes for Use
Location
• Place the appliance on a stable, horizontal, water-resist-
ant and level surface. Maintain a gap of at least 15 cm to
walls or objects.
• Do not place the appliance on or directly next to heat
sources such as ovens, radiators, etc.
Electrical Connection
1. Before inserting the plug into the socket. Make sure that
the mains voltage to be used matches that of the appli-
ance. You can nd this information on the nameplate.
2. Connect the appliance to a properly installed wall outlet.
Standby (Standby Mode)
If no control lamp is lit, the appliance is in standby mode.
Ice Cube Size
You may choose between 2 sizes:
- small ( – small icon)
- large ( – large icon)
Eco Save (Power Saving Mode)
Once the ice cube container is full the appliance switches
into standby mode.
You benet from better safety and lower energy consump-
tion.
Operation
When using the appliance for the rst time or if you have not
used it for a long time, clean the appliance as described in
the chapter “Cleaning and Maintenance”.
Making Ice Cubes
1. Make sure that the water tank cap on the bottom of the
appliance is tightly closed.
2. Open the lid and take out the ice cube container.
3. Fill the container with water to no more than the MAX
mark. Only use drinking water to make ice cubes.
- For best results, aim for a water temperature of
between 7 °C and 20 °C as well as an ambient tem-
perature of between 16 °C and 25 °C.
- If you want clear ice cubes, use chilled drinking water
which has rstly been boiled.
4. Now put the ice cube container back in and close the lid.
5. Press the button to start ice cube production.
6. Select the desired ice cube size with the button. The
corresponding control lamp lights up.
- For hygienic reasons do not use the ice cubes from
the rst cycle.
- The rst few ice cubes will be small depending on the
water temperature and ambient temperature. The ice
cubes will only grow larger in the following cycle.
- Due to fast freezing the ice cubes can look “milky”.
This is the air trapped in the water and does not inu-
ence the quality of the ice cubes.
7. Keep the lid closed during ice cube production. An ice
cube making cycle lasts between 9 and 10 minutes.
Stop Ice Cube Production
Press the button to stop ice cube production.
- If operation is manually interrupted, water which is no
longer needed is fed back to the water tank. Only then
will the appliance stop. Half-nished ice cubes remain
suspended on the cooling rods. As soon as it is suf-
ciently thawed, it will fall off and drop into the ice cube
container.
Control Lamp (Ice Cube Container Full)
As soon as the ice cube container is full, the sensor stops
production.
The control lamp ashes. The appliance switches into
standby mode.
• Remove the ice cubes with the supplied ice cube scoop.
When removing the ice cube container, some water will
drip through the holes onto the oor.
• The control lamp turns off and a few moments later
ice cube production starts again.
Control Lamp (Water Rell)
The control lamp displays when there is too little water
in the water tank. Ice cube production is automatically
interrupted.
1. Press the button to switch off the appliance.
2. Open the lid.
3. Empty the ice cube container.
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ProfiCook EWB 1253 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ProfiCook EWB 1253 in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 2.46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info