722048
5
Zoom out
Zoom in
Previous page
1/60
Next page
5
Electrical Cables
If cables have to be fed through metal holes or other walls with sharp edges, use ducts or cable
bushings to prevent damage.
Do not lay cables which are loose or bent next to electrically conductive material (metal).
Do not pull on the cables.
Avoid to lay 230 V mains cable and 12 V DC cables in the same duct.
Prevent all cables from being stepped on, tripped over, or being damaged by e.g. sharp edges or hot
surfaces.
Intended use
The PRO-USER SINE WAVE INVERTER converts a 12V direct current voltage (e.g. a battery or another
12V source that can deliver the required current) into 200-240V 50Hz AC pure sine wave voltage. The
built-in USB-Ports are intended to power or charge 5V USB devices (the maximum current delivery has
to be kept in mind). The wired remote control enables the user to monitor and control the inverter in a
convenient way.
Only PSI1000 & PSI1500: With the built-in solar charge controller, connected PV panels up to 500W (but
max. 30A and 16-45V) can recharge a connected lead-acid battery.
Maintenance
The unit itself is maintenance-free. From time to time, make sure all cable connections are clean and
tight and fans are working correctly. If necessary, clean the unit with care, using a dry cloth. Don’t try to
open the body casing. There are no user-serviceable parts inside. Damage due to improper use,
modifications or attempted repairs lead to the exclusion of liability and the loss of warranty. If the unit
is damaged, the appliance must be discarded. Cleaning and user maintenance shall not be made by
children.
Packaging materials
To avoid danger of suffocation, do not let children play with foils or other packaging materials. Remove
all protective coverings before putting the device in operation.
Storage
When not in use, store the inverter in a dry environment. Store the device in a safe place out of the reach
of children. Protect the unit from direct sunlight, heat and moisture.
Pro-User Pure Sine Wave Inverter
Wired remote control unit with connection cable
Operating manual
GENERAL INSTRUCTIONS
SCOPE OF DELIVERY
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pro-User PSI600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pro-User PSI600 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info