677795

Pro-User MCH8A Manual

4
Zoom out
Zoom in
Previous page
1/44
Next page
4
Storing of the cables
Included with the Battery charger are 4 pieces of “U”
shaped brackets. These should be assembled to the
rear of the charger. Both mains and
DC leads can be winded onto these
brackets for storage.
OPERATION
PLEASE READ CAREFULLY BEFORE USING
Suitable for all type of 12V lead acid, sealed, leisure and gel cell batteries
between 20-150Ah.
1. Preparing the battery
Firstly remove the caps from each cell and check that the level of the liquid is sufficient in
each cell. If it is below the recommended level, top up with de-ionized or distilled water.
Note: Under no circumstances should tap water be used.
The cell caps should not be replaced until charging is complete. This allows any gases
formed during charging to escape. It is inevitable that some minor escape of acid will
occur during charging.
For permanently sealed battery, it is not necessary to carry out the above checks.
2. Connection
Connect the positive charging lead (red) to the positive terminal post of the battery
(marked P or +). Connect the negative charging lead (black) to the negative terminal
post of the battery (marked N or -).
It is important to ensure that both DC clamps are making good contact with their
respective terminal posts. If the DC battery clamps are connected improperly to the
battery terminals, the reverse polarity LED will indicate the reversed polarity. If this
occurs simply disconnect the battery charger from the AC power connect the DC clamps
correctly to the battery terminals. Reconnect the charger to the AC power.
3. Selection of battery type
When a standard type lead acid battery
(including sealed, leisure) is to be charged,
switch the battery type selector to NORMAL.
When a Gel Cell type battery is to be
charged, switch the selector to GEL CELL.
Dependent on the type of battery you have
selected, the battery charger will
automatically switch to maintenance mode
at different cut-off full voltage level.
4. Selection of current (Trickle Charge / Fast Charge)
Your battery charger is equipped with a slow/fast charge selector. If you are charging a
small lead acid battery, or you only require a slow charge, then you should toggle the
rocker switch to TRICKLE CHARGE. If, however, you are charging a large, or leisure type
battery, or you require a quick boost charge then you should toggle the switch to FAST
CHARGE.
5. Charging
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pro-User MCH8A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pro-User MCH8A in the language / languages: English, German, Dutch, French, Italian, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 8,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info