558802
93
Zoom out
Zoom in
Previous page
1/100
Next page
93
Initial operation
Note: The following steps for the putting your new eBench Dolby ProLogic Surround System KH 02
into operation mainly refer to the connect of a television as an output device (e.g. for viewing
DVDs and videos or for video games). If you would like to connection other devices (e.g. hi-
equipment) you can proceed analogously to the steps described here for the most part. If in
doubt, consult the operating manual of the respective device.
Remove your new eBench Dolby ProLogic Surround System KH 02 carefully from the packaging.
Keep the box for transport or storage of the system. The packaging contains the following com-
ponents:
Amplier
Loudspeakers
1 amplier
1 subwoofer with mains connection
1 centre speaker
2 front satellite loudspeakers
2 effect satellite loudspeakers
Remote control
Infrared remote control incl. 2 batteries
Inserting the batteries in the remote control
1. Open the battery compartment on the reverse of the remote control.
2. Insert the two batteries, making sure that correct polarity.
3. Close the battery compartment.
4. The range of the remote control is approximately 7 m. Please make sure that a maximum
angle of 30 degrees not exceeded when directing the remote control towards the amplier.
Note: Remove the batteries from the remote control if it is not going to be used for a longer period.
Setting up the loudspeakers
Before you connect the amplier, the centre speaker, the front and the effect loudspeakers and
the signal source(s) to the subwoofer, you should set up the loudspeakers in such a way that you
get an optimum cinema sound effect in your living room. Follow the drawing below to achieve
this effect.
The subwoofer should be placed on the oor at the front of the room. It can be placed near to the
television set or in a corner. The rear panel of the loudspeaker should be 10 to 15 cm away from the
wall in order to achieve the correct tonal balance and to allow the heat to be drawn off.
OPERATING MANUAL
93


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pro-Logic KH 02 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pro-Logic KH 02 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 3,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info