7
4. Tip: Be careful not to pinch the Wire Harness
(49) during this step.
Orient the Water Bottle Holder (5) as shown and
slide it onto the Upright (2). Attach the Water
Bottle Holder with two M4 x 32mm Screws (95).
Slide the Console Cover (96) onto the Upright
(2) and move it downward to the Water Bottle
Holder (5). Then, insert the Console Bracket (3)
into the top of the Upright. Attach the Console
Bracket with four M4 x 12mm Screws (99).
4
3. Tip: Be careful not to pinch the Wire Harness
(49) during this step.
Have another person hold the Upright (2) near
the Frame (1). Locate the wire tie in the Upright.
Tie the lower end of the wire tie to the Wire
Harness (49). Next, pull the upper end of the
wire tie upward out of the top of the Upright.
Then, untie and discard the wire tie. Tip: To
prevent the Wire Harness from falling inside
the Upright, secure the Wire Harness with a
rubber band.
Attach the Upright (2) to the Frame (1) with four
M10 x 20mm Patch Screws (79), and four M10
Split Washers (78). Tip: Tighten the two Patch
Screws on the front of the elliptical exerciser
before tightening the other two Patch
Screws.
3
Avoid pinching the
Wire Harness (49)
during this step
Avoid pinching
the Wire
Harness (49)
during this step
2
1
49
78
78
78
79
79
79
99
99
95
49
96
3
5
Wire Tie
2
