4
2b
D
B
1. Make sure that the power cord is unplugged. Remove
the indicated Screws (A) from the Console Back (B).
Remove the Console Back from the Console Base (E).
2. Connect the included Short Jumper Wire (C) to the wire on
the Receiver (D). Connect the other end of the Short
Jumper Wire to the PULSE jack on the back of the
Console (see drawing 2b). If there is a wire already
plugged into the PULSE jack, unplug it. Next, peel the
paper off the pad on the back of the Receiver (D). Turn
the Receiver so the cylinder is on the side shown, hold
the Receiver inside of the Console Base (B), and press
the Receiver onto the bottom of the Console Base in the
location indicated by the dotted line. Note: The other wires
included with the receiver may be discarded. The Wire Tie
can be used to tie wires, if needed.
Make sure that no wires are pinched. See step 1.
Reattach the Console Back (B) with the Screws (A).
B
E
A
1
C
2a
Cylinder
1. Make sure that the power cord is unplugged. Remove
the indicated Screws (A) from the Console Back (B).
Remove the Console Back from the Console Base (C).
2. Connect the included Long Jumper Wire (D) to the wire on
the Receiver (E). Feed the Long Jumper Wire through the
Console (F) as shown. Connect the other end of the Long
Jumper Wire to the PULSE jack on the back of the
Console. If there is a wire already plugged into the PULSE
jack, unplug it. Turn the Receiver so the cylinder is on
the side shown, and press the Receiver onto the back of
the Console Base (C) in the indicated location. Note: The
other wires included with the receiver may be discarded.
The Wire Tie can be used to tie wires, if needed.
Make sure that no wires are pinched. See step 1.
Reattach the Console Back (B) with the Screws (A).
B
C
A
1
PULSE
Jack
2
E
Cylinder
F
D
C
PULSE
Jack
