553945
25
Zoom out
Zoom in
Previous page
1/36
Next page
25
TROUBLESHOOTING
M
ost treadmill problems can be solved by following the steps below. Find the symptom that applies, and
follow the steps listed. If further assistance is needed, please see the front cover of this manual.
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a properly earthed outlet (see page 15). If an ex-
tension cord is needed, use only a 3-conductor, 14-gauge (1 mm
2
) cord that is no longer than 5 ft.
(1.5 m).
b. Afterthepower cord has been plugged in, makesure that the key is inserted into the console.
c. Check the power switch located on the treadmill
frame near the power cord. If the switch protrudes
as shown, the switch has tripped. To reset the
switch, wait for five minutes and then press the
switch back in.
PROBLEM:The power turns off during use
SOLUTION: a. Check the power switch (see the drawing above). If the switch has tripped, wait for five minutes
and then press the switch back in.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for
five minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key into the console.
d. If the treadmill still will not run, please see the front cover of this manual.
PROBLEM: The console displays remain lit when you remove the key from the console
SOLUTION: a. The console features a display demo mode, designed to be used if the treadmill is displayed in a
store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off
the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE
INFORMATION MODE on page 23 to turn off the demo mode.
PROBLEM:The displays of the console do not function properly
SOLUTION: a. Press the Incline buttons and adjust the incline level
of the treadmill to 5 percent.
Remove the keyfrom the console and UNPLUG
THE POWER CORD. With the help of a second
person, carefully tip down the Uprights (85, 89).
There may be two Belly Pan Screws (A) in the bot-
tom of the Belly Pan (84). If there are, remove
them. Note: A Phillips screwdriver with a shaft at
least 5in. (13 cm) long is required.
Then, raise the Uprights (85,89).
Tripped Reset
c
A
A
85
89
a
84
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pro-form 500 ZLT - PETL59910 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pro-form 500 ZLT - PETL59910 in the language / languages: English as an attachment in your email.

The manual is 2,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pro-form 500 ZLT - PETL59910

Pro-form 500 ZLT - PETL59910 User Manual - German - 36 pages

Pro-form 500 ZLT - PETL59910 User Manual - Dutch - 36 pages

Pro-form 500 ZLT - PETL59910 User Manual - French - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info