6
Option A blow dry
Result: wild and carefree
Option B: blow dry with a flat brush
Result: smooth and shiny
BLOW DRY WITH ROUND BRUSH
1. Twist the brush inwards from the hair ends to the roots.
2. Hold the hairdryer under the brush for a few seconds.
3. Allow your hair to cool off and then unwind the brush, in the same direction as the curl, out of your
hair.
Result: extra volume
CLEANING AND MAINTENANCE
Always pull the plug out of the socket first!
Clean the outside of your hairdryer with a damp cloth. Never immerse it in water or any other liquid!
Ensure that the air inlet at the back is not blocked with hairs and fluff. If required, clean out the grille
with a stiff brush or tweezers. Make sure the grille does not become blocked while drying.
IMPORTANT GUIDELINES
• When using the product in the bathroom, always remove the plug from the socket after use.
The close proximity of water can be dangerous, even if the appliance is switched off.
• For added protection in the power circuit in your bathroom, it is recommended you install a residual
current device with a nominal trip sensitivity not exceeding 30mA. Consult your installer for advice.
• When using rollers, etc. in your hair, we recommend that you be very careful with any pins and clips.
Take care that they cannot enter the ventilation and air openings in the dryer!
• After use, always pull the plug from the socket.
• Never direct a (hot) airflow at your eyes or sensitive parts of the face.
• Never use any spray cans near the hairdryer when it is switched on.
• Do not wind the lead wire too tightly around the hairdryer, this will prevent damage to the lead.
• Use only the original accessories supplied.
• Allow the hairdryer to cool down before putting it away.
• Do not lay a switched on and/or hot hairdryer on soft furnishings, such as a bed, cushion, etc. This will
prevent over-heating.
• Instruct young children about the dangers and safety rules concerning electrical equipment.
• Never let young children use electrical equipment without supervision.
• Do not attempt to lubricate this hairdryer. Repairs and service should always be carried out by an
expert Service Department.
• Do not use the appliance if it is damaged or if the cable is damaged. Instead, send it to a service depart-
ment. The lead on this appliance can only be replaced by our Service Department using special tools.
• This hairdryer is intended for normal household use only.
U.K. WIRING INSTRUCTIONS
The wires in the mains lead are coloured in accordance with the following code:
BLUE-neutral BROWN-LIVE
As the colours of the wire in the mains lead of this appliance may not correspond with the
colour markings identifying the terminals on your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with
the letter N or coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked
with the letter L or coloured red.
