Keep the appliance away from heat sources.
Do not immerse the appliance in water or
other liquids. If the appliance is immersed
in water or other liquids, do not remove the
appliance with your hands. Immediately
remove the mains plug from the wall socket.
If the appliance is immersed in water or
other liquids, do not use the appliance again.
The accessible surfaces of the appliance
can become very hot during use. Do not
touch the accessible surfaces. Only touch
the handgrips when the accessible surfaces
are hot.
Do not move the appliance while it is
switched on or is still hot. Remove the
mains plug from the wall socket and wait
until the appliance has cooled down.
Beware of hot steam when opening the lid.
Make sure that the heating element and
the outside of the inner pot are clean and
dry before inserting the mains plug into the
wall socket.
Do not cover the steam vent and the lid
when the appliance is operating.
U.K. Wiring instructions
The wires in the mains lead are coloured in
accordance with the following code:
BLUE NEUTRAL
BROWN LIVE
GREEN/YELLOW EARTH
As the colours of the wire in the mains lead of
this appliance may not correspond with the
colour markings identifying the terminals on
your plug, proceed as follows:
The wire which is coloured BLUE must be
connected to the terminal which is marked
with the letter N or coloured black.
The wire which is coloured BROWN must be
connected to the terminal which is marked
with the letter L or coloured red.
The wire which is coloured GREEN/YELLOW
must be connected to the terminal which is
marked with the letter E or (
) and is coloured
GREEN or GREEN/YELLOW.
Do not use the appliance if any part is
damaged or defective.
Have any damaged or defective part
repaired or replaced by an authorised
repair agent.
Never attempt to remove or replace any
parts other than those specified in this
manual.
Before use, check the mains cable for wear
or damage.
Do not use the appliance if the mains cable
or mains plug is damaged or defective.
If the mains cable or mains plug is damaged
or defective, it must be replaced by the
manufacturer or an authorised repair agent.
Safety instructions
for rice cookers
Before use, always check that the mains
voltage is the same as the voltage on the
rating plate of the appliance.
Connect the appliance to an earthed wall
socket. If necessary, use an earthed
extension cable of a suitable diameter
(at least 3 x 1 mm
2
).
For additional protection, install a residual
current device (RCD) with a rated residual
operating current that does not exceed
30 mA.
The appliance is not intended to be operated
by means of an external timer or separate
remote-control system.
Make sure that water cannot enter the
contact plugs of the mains cable and the
extension cable.
Always fully unwind the mains cable and
the extension cable.
Only use the appropriate connector to
operate the appliance.
Place the appliance on a stable and flat
surface.
Place the appliance on a heat-resistant
and splash-proof surface.
Do not place the appliance on a hob.
Make sure that there is sufficient space
around the appliance to allow heat to escape
and provide sufficient ventilation.
Do not cover the appliance.
Make sure that the appliance does not
come into contact with flammable material.
