722013
31
Zoom out
Zoom in
Previous page
1/108
Next page
MV600 31
Your vehicle requires a minimal amount of care and maintenance. If you do not feel con dent in your ability to
perform the maintenance listed below, you may schedule inspection and maintenance at your authorized dealer.
The following areas require periodic inspection and/or care and maintenance.
TIRE PRESSURE – PNEUMATIC TIRES
If equipped with pneumatic tires, always maintain the psi/bar/kPa air pressure rating indicated on each tire.
WARNING! It is important that the psi/bar/kPa air pressure rating indicated on each tire be
maintained in pneumatic tires at all times. Do not underin ate or overin ate your tires. Low
pressure may result in loss of control, and overin ated tires may burst. Failure to maintain the
psi/bar/kPa air pressure rating indicated on the tires at all times may result in tire and/or wheel
failure.
Regularly inspect your vehicle’s tires for signs of damage or wear.
EXTERIOR SURFACES
Bumpers, tires, and trim can bene t from an occasional application of a rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the vehicle’s vinyl seat or tire tread, as
this may cause them to become dangerously slippery.
CLEANING AND DISINFECTION
Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your vehicle. Avoid
using products that may scratch the surface of your vehicle.
If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for use on
your product before application.
WARNING! Follow all safety instructions for the proper use of the disinfectant and/or cleaning
agent before applying it to your product. Failure to comply may result in skin irritation or
premature deterioration of upholstery and/or vehicle nishes.
BATTERY TERMINAL CONNECTIONS
Make certain that the terminal connections remain tight and uncorroded.
The batteries must sit at in the battery wells.
The battery terminals should face according to the battery wiring diagram. See III. “Batteries and Charging.”
WIRING HARNESSES
Regularly check all wiring connections.
Regularly check all wiring insulation, including the charger power cord, for wear or damage.
Have your authorized dealer repair or replace any damaged connector, connection, or insulation that you nd
before using your vehicle again.
PROHIBITED! Even though the vehicle has passed the necessary testing requirements for ingress
of liquids, you should keep electrical connections away from sources of dampness, including
direct exposure to water or bodily uids and incontinence. Check electrical components
frequently for signs of corrosion and replace as necessary.
WARNING! Do not pull on electrical harnesses directly to detach them from the vehicle. Always
grasp the connector itself when disconnecting the harness to prevent wire damage.
VIII. CARE AND MAINTENANCE
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pride Wrangler at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pride Wrangler in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 3,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info