668221
33
Zoom out
Zoom in
Previous page
1/40
Next page
Revo www.pridemobility.com 33
IX. BASIC TROUBLESHOOTING
Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that
may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because
the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.
DIAGNOSTIC FLASH CODES
The diagnostic flash codes for your scooter are designed to help you perform basic troubleshooting quickly and easily.
A diagnostic flash code will flash from the status LED in the event one of the conditions listed below develops.
NOTE: Your scooter will not run unless the flash code condition is resolved and the scooter has been
turned off, and then back on.
What if all the systems on my scooter seem to be “dead?”
Make certain that the key is in the “on” position.
Check that the batteries are fully charged.
Push in the main circuit breaker reset button. See IV. “Your Scooter.”
Make certain that both batteries are seated properly.
Make sure that the front-to-rear harness is firmly connected. See VIII. “Disassembly and Assembly.”
Be sure the power down timer feature hasn’t been activated. See VI. “Operation.”
What if my scooter does not move when I press the throttle control lever?
When the manual freewheel lever is pushed forward, the brakes are disengaged and all power to the motor/
transaxle assembly is cut.
Push back on the manual freewheel lever, turn the scooter off, and then turn the scooter on to return to normal
scooter operation.
FLASH CODE CONDITION SOLUTION
(1) Battery charge is low. Charge batteries.
(2) Batteries are too low to operate the Charge batteries or unplug the
scooter or the charger is operating. chargerpower cord from the electrical outlet.
(3) The scooters battery voltage is too Insert the key into the key switch, turn the
high to operate the scooter. scooters light on to drain power from the
batteries.
(4) Current limit time out. Turn the scooter off for a few minutes then
turn the scooter back on.
(5) The manual freewheel lever is in the Remove the key from the key switch, then
(forward) freewheel position. push the manual freewheel lever to the (rear)
drive position and restart your scooter.
(6) Throttle control lever not at centre Return the throttle control lever to centre
position at start up. position, turn scooter off, and then on.
(7) Speed pot error. Contact your authorized Pride Provider for
assistance.
(8) Motor volts error. Contact your authorized Pride Provider for
assistance.
(9) Motor volts error. Contact your authorized Pride Provider for
assistance.
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pride Revo at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pride Revo in the language / languages: English as an attachment in your email.

The manual is 2,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pride Revo

Pride Revo User Manual - German - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info