721832
19
Zoom out
Zoom in
Previous page
1/108
Next page
MV600 19
III. BATTERIES AND CHARGING
You may need the following to change your batteries:
Metric/standard socket set and ratchet
Adjustable wrench
WARNING! Do not lift beyond your physical capability. Ask for assistance when necessary while
disassembling or assembling your vehicle.
WARNING! Do not pull on electrical harness wires directly to detach them from the vehicle.
Always grasp the connector itself when disconnecting the harness to prevent wire damage.
NOTE: If you encounter a damaged or cracked battery, immediately enclose it in a plastic bag. Contact your
local waste disposal agency or your authorized dealer for instructions on disposal and battery recycling, which
is our recommended course of action.
To change batteries in your vehicle:
1. Remove the seat by lifting it straight up and off of the vehicle. If
you encounter resistance when removing the seat, disengage the
seat rotation lever and swivel the seat back and forth while lifting
up on the seat.
2. Remove the rear shroud by lifting it straight up and off the vehicle.
The shroud is secured to the vehicle with reusable fasteners and two
(2) thumbscrews. See gure 12.
3. Remove the battery shroud by removing the four (4) thumbscrews
that secure it to the vehicle frame, and then lifting the shroud straight
up and off of the vehicle. See gure 12.
4. Disconnect the battery tie-down straps.
5. Disconnect the battery cables from the battery terminals by sliding
back the terminal boots and unscrewing the nut from the bolt. See
gure 14.
6. Remove the old batteries from the battery wells.
7. Place a new battery in each battery well. Face the battery terminals
of each battery away from the seat post.
See gure 15.
NOTE: Use battery straps to secure batteries in the battery wells.
Please refer to gures 13 and 16 for battery strap installation
procedures.
8. Connect the red battery cable to the positive (+) battery terminal on
each battery.
9. Connect the black battery cable to the negative (-) battery terminal
on each battery.
10. Reposition the terminal boots over the battery terminals.
11. Reconnect the battery tie-down straps.
12. Reinstall the battery shroud, the rear shroud and the seat.
Figure 12. Battery Shroud Removal/
Installation
1
3
1
2
IDENTIFICATION KEY
1. THUMBSCREW
2. REAR SHROUD
3. BATTERY SHROUD
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pride Ranger - MV600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pride Ranger - MV600 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 2,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pride Ranger - MV600

Pride Ranger - MV600 User Manual - German, Dutch, Italian - 108 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info