668245
12
Zoom out
Zoom in
Previous page
1/32
Next page
12 www.pridemobility.com Quantum 610 Series
IV. ASSEMBLY
Seat Installation
It may be necessary to install the seat either prior to initial
operation or after transporting your power chair. Most
seats are attached to the power base with the Universal
Mounting System (UMS). The UMS consists of universal
parts that may be attached to any medium-back or high-back
seat, regardless of seat width or seat depth. The two main
components are aluminum extrusions mounted to the seat
base. These extrusions attach to a pair of trapeze bars that are
mounted to the power base. See gure 7.
NOTE: If your power chair is equipped with a Synergy Seat
or a TRU-Balance
®
Power Positioning System, refer to the
information provided in separate manuals.
WARNING! Do not pick up the seat frame by
the armrests. They are free to pivot, and you
may lose control of the seat if they do so.
To install the seat:
1. Tilt the seat back and slide the rear extrusion onto the
rear trapeze bar. See gure 7.
2. Lower the front extrusion onto the front trapeze bar until
the seat locks into place.
3. Flip the seat latch safety down. See gure 7.
WARNING! Make sure the seat latch safety is
ipped down before using your power chair.
4. Install the controller and route the harness to the back of
the power base. See gure 8.
5. Loosen the rear shroud fasteners and remove the rear
shroud. See gure 2.
6. Plug the controller connector into the power base. See
gure 3.
7. Reinstall the rear shroud and tighten the rear shroud
fasteners. See gure 2.
8. Route the controller harness so that it cannot be pinched
in the seat hinge.
MANDATORY! Prevent controller harness
damage! Use correct tie-down points
for controller harness. Avoid routing the
controller harness on the outside of the
armrest pad. Route the harness under the
armrest or toward the inside of the armrest
pad. Use correct tie-down points for the
controller harness to prevent the harness
from getting caught in the drive tires,
pinched in the seat frame, or damaged when
passing through doorways.
9. Secure the controller harness to the armrest receiver with
wire ties. See gure 9.
Figure 7. Universal Mounting System
Figure 8. Controller Routed on a Synergy Seat
REAR TRAPEZE
BAR
REAR LATCH
SAFETY
REAR
EXTRUSION
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pride QUANTUM 610 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pride QUANTUM 610 in the language / languages: English as an attachment in your email.

The manual is 2,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info