668244
13
Zoom out
Zoom in
Previous page
1/36
Next page
Q6 Edge www.pridemobility.com 13
Seat Installation
It may be necessary to install the seat either prior to
initial operation or after transporting your power chair.
NOTE: If your power chair is equipped with a power
positioning system, refer to the information provided
in separate manuals.
WARNING! Do not pick up the seat
frame by the armrests. They are free to
pivot, and you may lose control of the
seat if they do so.
To install the seat:
1. Tilt the seat back and align the interfaces on the
bottom rear of the seat with the rear seat secure-
ment brackets on the power base and secure with
the hardware. See figure 7.
2. Pivot the seat down and secure the front seat inter-
face into the top of the actuator with the detent pin.
WARNING! Make sure the hardware
and detent pin are properly secured
before using your power chair.
3. Install the controller and route the harness to the
back of the power base. See figure 6.
MANDATORY! Prevent controller
harness damage! Avoid routing the
controller harness on the outside of
the armrest pad. Route the harness
under the armrest or toward the inside
of the armrest pad. Use correct tie-
down points for controller harness to
prevent the harness from getting
caught in the drive tires, pinched in the
seat frame, or damaged when passing
through doorways.
4. Plug the controller connector into the rear of the
power base. See figure 3.
5. Secure the controller harness to the armrest
receiver with wire ties. See figure 8.
IV. ASSEMBLY
Figure 7. Universal Mounting System
INTERFACE
ON BOTTOM
REAR OF
SEAT
TOP OF THE
ACTUATOR
REAR SEAT
SECUREMENT
BRACKET
Figure 8. Controller Harness Routing
FRONT SEAT
INTERFACE
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pride Q6 Edge at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pride Q6 Edge in the language / languages: English as an attachment in your email.

The manual is 13,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info