721996
33
Zoom out
Zoom in
Previous page
1/43
Next page
Maxima 33
www.pridemobility.com
Any electromechanical device occasionally requires some troubleshooting. However, most of the
problems that may arise can usually be solved with a bit of thought and common sense. Many of these
problems occur because the batteries are not fully charged or because the batteries are worn down and can
no longer hold a charge.
DIAGNOSTIC FLASH CODES
The diagnostic flash codes for your scooter are designed to help you perform basic troubleshooting quickly
and easily. A diagnostic flash code flashes from the status LED in the event one of the conditions listed
below develops.
NOTE: Your scooter will not run unless the flash code condition is resolved and the scooter has been
turned off, then turned back on.
What if all the systems on my scooter seem to be “dead”?
Make certain that the key is in the “on” position.
Check that the batteries are fully charged. See IV. “Batteries and Charging.”
Push in the main circuit breaker reset button. See III. “Your Scooter”
Make certain that both battery harnesses are firmly connected to the electronics module and to the
battery terminals. See VII. “Disassembly and Assembly.”
Make sure that the front-to-rear harness is firmly connected to the electronics module. See VII.
“Disassembly and Assembly.”
Check the fuses. See IX. “Care and Maintenance” for fuse replacement.
Be sure the power down timer feature has not been activated. See V. “Operation.”
FLASH CODE CONDITION SOLUTION

(2)
Battery voltage is too low to operate the
scooter.
Charge fully until charger and any meters
indicate completion.

(3)
Battery voltage is too high to operate the
scooter.
Contact your authorised Pride Dealer for
assistance.

(5)
Solenoid brake trip. The manual freewheel
lever may be in the freewheel position.
Remove the key, then push the manual free-
wheel lever to the drive position, restart your
scooter.

(6)
Throttle trip. The throttle control lever
may have been depressed while inserting
the key.
Release the throttle control lever completely,
then reinsert the key.

(7)
Throttle trip. The throttle control lever
may have been depressed while inserting
the key.
Contact your authorised Pride Dealer for
assistance.

(8)
The scooter’s motor is disconnected. Contact your authorised Pride Dealer for
assistance.

(9)
Possible controller trip. You may be
attempting to install the battery while the
key is inserted or the motor controller may
be in overheat protective mode.
Shut down your scooter for a minimum of sev-
eral minutes to allow the controller to cool. Or,
try reinserting the key into the key switch.
VIII. BASIC TROUBLESHOOTING
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pride Maxima at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pride Maxima in the language / languages: English as an attachment in your email.

The manual is 4,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info