514964
31
Zoom out
Zoom in
Previous page
1/42
Next page
31
Go-Go Ultra X www.pridemobility.com
VIII. BASIC TROUBLESHOOTING
Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that
may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because
the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.
DIAGNOSTIC BEEP CODES
The diagnostic beep codes for your Travel Scooter are designed to help you perform basic troubleshooting quickly
and easily. A diagnostic beep code will sound in the event one of the conditions listed below develops.
NOTE: Your Travel Scooter will not run unless the beep code condition is resolved and the Travel
Scooter has been turned off, then turned back on.
BEEP CODE CONDITION SOLUTION
! ! (2) Battery voltage is too low to operate the
Travel Scooter.
Charge f ully until c harger a nd any meters
indicate completion.
! ! ! (3) Battery voltage is too high to operate the
Travel Scooter.
Contact your authorized P ride P rovider for
assistance.
! ! ! ! ! (5) Solenoid brake trip. The manual freewheel
lever may be in the freewheel position.
Remove t he ke y, t hen p ush the manual
freewheel lever to the drive position, restart
your travel Scooter.
! ! ! ! ! ! (6) Throttle trip. The throttle control lever
may have been depressed while inserting
the key.
Release the throttle c ontrol le ver
completely, then reinsert the key.
! ! ! ! ! ! ! (7) Throttle trip. Throttle potentiometer fault
or speed potentiometer fault.
Contact your authorized P ride P rovider for
assistance.
! ! ! ! ! ! ! ! (8) The Travel Scooter’s motor is
disconnected.
Contact your authorized P ride P rovider for
assistance.
! ! ! ! ! ! ! ! ! (9)
Possible controller trip. You may be
attempting to install the battery pack while
the key is inserted or the motor controller
may be in overheat protective mode.
Shut d own y our T ravel Sc ooter f or a
minimum of se veral minutes to a llow th e
controller to cool. Or, try reinserting the key
into the key switch.
What if all the systems on my Travel Scooter seem to be “dead”?
!Make certain that the key is in the “on” position.
!Check that the batteries are fully charged.
!Push in the main circuit breaker reset button. See III. “Your Travel Scooter.”
!Make certain that the battery pack is seated properly.
!Be sure the power down timer feature has not been activated. See V. “Operation.”
!Check the tiller console fuse located under the battery pack.
To check a fuse:
1. Remove the fuse by pulling it out of its slot.
2. Examine the fuse to be sure it is blown. See figures 20 and 21.
3. Insert a new fuse of the proper rating.
WARNING! The replacement fuse must exactly match the rating
of the old fuse. Failure to use properly rated fuses may cause
damage to the electrical system.
Figure 20. Working Fuse
Figure 21. Blown Fuse
(Replace)
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pride Go Go Ultra X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pride Go Go Ultra X in the language / languages: English as an attachment in your email.

The manual is 1.41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pride Go Go Ultra X

Pride Go Go Ultra X User Manual - English - 108 pages

Pride Go Go Ultra X User Manual - German, Dutch - 108 pages

Pride Go Go Ultra X User Manual - Dutch - 44 pages

Pride Go Go Ultra X User Manual - French - 108 pages

Pride Go Go Ultra X User Manual - Italian - 108 pages

Pride Go Go Ultra X User Manual - Spanish - 108 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info