668252
11
Zoom out
Zoom in
Previous page
1/32
Next page
11
Seat Installation
It may be necessary to install the seat either prior to initial
operation or after transporting your Go-Chair. The seat is
attached to the power base by a height-adjustable seat
post.
WARNING! Do not pick up the seat frame
by the armrests. They are free to pivot,
and you may lose control of the seat if
they do so.
To install the seat:
1. Adjust the seat height if necessary. See “Comfort
Adjustments.
2. Set the seat onto the seat post. See fi gure 5.
3. Install under-seat storage. See “Comfort Adjustments.
4. Install the controller into the armrest, and tighten the
setscrew under the armrest.
5. Route the controller harness to the rear of the power
base.
6. Plug the controller harness connector into the power
base.
7. Secure the controller harness to the armrest with
wire ties. See fi gure 5.
MANDATORY! Prevent controller harness
damage! Avoid routing the controller
harness on the outside of the armrest
pad. Route the harness under the armrest
or toward the inside of the armrest pad.
Use correct tie-down points for the
controller harness to prevent the harness
from getting caught in the drive tires,
pinched in the seat frame, or damaged
when passing through doorways.
Disassembly
The Go-Chair disassembles into fi ve components: the
seat, the under-seat storage bin, the battery box, the
rear section of the power base, and the front section of
the power base. See fi gure 6.
To disassemble the Go-Chair:
1. Turn off the power to the controller.
2. Place the Go-Chair in drive mode, if not in drive mode
already. See “Your Go-Chair.
3. Unplug the controller from power base.
4. Remove under-seat storage. See “Comfort
Adjustments.
5. Remove the seat by lifting it straight up and off of the
Go-Chair. If you encounter resistance when removing
the seat, disengage the seat release lever and swivel
the seat back and forth while lifting up on the seat.
6. Grasp the battery box handle and lift up to disengage
the box from the power base, then tilt the box foward
slightly and pull it away from the power base.
7. Disconnect two halves using the frame release lever.
1
2
Figure 5. Seat Installation
1
3
4
5
2
6
Figure 6. Go-Chair Components
Identifi cation Key
Identifi cation Key
1. Seat
2. Seat Release Lever
3. Under Seat Storage
4. Front Section
5. Rear Section
6. Battery Box
1. Wire Tie
2. Controller Connector
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pride Go-Chair at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pride Go-Chair in the language / languages: English as an attachment in your email.

The manual is 7,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pride Go-Chair

Pride Go-Chair User Manual - Dutch - 44 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info