721998
36
Zoom out
Zoom in
Previous page
1/42
Next page
36 Cyclone
Any electromechanical device requires occasional troubleshooting. However, most problems that arise can be
solved with a bit of thought and common sense. Many of these problems occur because the batteries are not fully
charged or because the batteries are worn down and can no longer hold a charge.
DIAGNOSTIC BEEP CODES
Diagnostic beep codes help you to perform basic troubleshooting quickly and easily. A diagnostic beep code will
sound in the event one of the conditions listed below develops. After you perform the solution associated with the
diagnostic beep code, your Cyclone should resume normal operation.
NOTE: Your Sport Scooter will not run unless the beep code condition is resolved and the Sport Scooter
has been turned off and then turned back on.
X. BASIC TROUBLESHOOTING
What if all the systems on my Cyclone seem to be dead?
n Make certain that the key is in the on position.
n Check that the batteries are fully charged. See V. Batteries and Charging.
n Push in the main circuit breakers reset button. See IV. Your Cyclone.
n Make certain that both battery harnesses are firmly connected to the electronics module and to the battery
terminals. See VIII. Disassembly and Assembly.
n Make sure that the front-to-rear harness is firmly connected to the electronics module. See VIII. Disassembly
and Assembly.
n Be sure the auto shutoff feature hasnt been activated. See V. Batteries and Charging.
n Check the fuses. See XI. Care and Maintenance for fuse replacement.
What if the motor runs but my Cyclone does not move?
n Your Cyclone was probably left in manual freewheel mode.
n When the manual freewheel lever is pulled up, the brakes are disengaged and all power to the transaxle is cut.
n Turn the Sport Scooter key to the off position.
n Push the manual freewheel lever down.
n Turn the Sport Scooter key to the on position to restore normal operation.
BEEP CODE CONDITION SOLUTION
1 beep every 5 seconds Batteries are getting low. Charge batteries as soon as possible.
2 beeps every 5 seconds Batteries are too low to operate the
Cyclone or the charger is operating.
Charge batteries or unplug the charger power
lead from the electrical outlet.
3 beeps every 5 seconds Controller is hot; the Sport Scooter
seems to be losing power.
Shut down your Cyclone for a minimum of
several minutes to allow the controller to
cool.
4 beeps every 5 seconds Wigwag fault; your throttle control
levers are not responding.
Call your authorised Pride provider for
assistance.
6 beeps every 5 seconds The manual freewheel lever is in the
freewheel (up) position.
Turn the Cyclone key to the “off” position,
push the manual freewheel lever to the drive
(down) position, restart your Cyclone.
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pride Cyclone at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pride Cyclone in the language / languages: English as an attachment in your email.

The manual is 0,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info