721998

Pride Cyclone Manual

32
Zoom out
Zoom in
Previous page
1/42
Next page
32 Cyclone
No tools are required to disassemble or assemble your Cyclone. Always disassemble or assemble your Cyclone
on a level, dry surface with sufficient room for you to work and move around your Sport Scooter. Keep in mind
that the disassembled sections of the Cyclone take up more floor space than the assembled Cyclone.
DISASSEMBLY
You can disassemble the Cyclone into seven pieces: the seat, the front section, the rear section, the rear shroud,
the basket, and the batteries. Place the Sport Scooter in an area where you have sufficient clearance to move the
parts around. You need about one or two meters in all directions. You may need assistance to lift some of the Sport
Scooter components. See III. Specifications for individual component weights.
Before beginning disassembly, place the manual freewheel lever in the drive (down) position. Also, coil the charger
power lead and store it in the rear charger power lead storage compartment. See figure 8.
VIII. DISASSEMBLY AND ASSEMBLY
WARNING! If you believe that lifting any component of the Cyclone is beyond your physical capa-
bility, have someone with ample strength lift it for you. See III. Specifications for Scooter compo-
nent weights.
1. Push down on the seat rotation lever to unlock the seat. Rotate the seat one-eighth (1/8) of a turn, and lift the
seat up and off the Cyclone. See figure 18.
2. Gently lift the rear shroud off of the Cyclone. See figure 19.
3. Disconnect the battery tie-down straps (if so equipped).
4. Unplug both black and white 2-pin battery harnesses. See figure 20.
5. Unplug the front-to-rear harness that connects the control console assembly to the electronics module. See
figure 21.
CAUTION! Failure to unplug both battery harnesses and the front-to-rear harness prior to
disassembly could result in damage to the Cyclone.
FIGURE 18. SEAT REMOVAL
FIGURE 19. REAR SHROUD REMOVAL
FIGURE 21. DISCONNECTING THE FRONT-TO-REAR HARNESSFIGURE 20. DISCONNECTING THE BATTERY HARNESSES
… 32 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pride Cyclone at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pride Cyclone in the language / languages: English as an attachment in your email.

The manual is 0,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info