721987
24
Zoom out
Zoom in
Previous page
1/48
Next page
24
www.pridemobility.com Colt Pursuit
WARNING! When your scooter is in freewheel mode, the braking system is disengaged.
Disengage the drive motors only on a level surface.
Ensure the key is removed from the key switch.
Stand to the side of the scooter to engage or disengage freewheel mode. Never sit on
a scooter to do this.
After you have finished pushing your scooter, always return it to the drive mode to lock
the brakes.
NOTE: If the scooter is placed in freewheel mode (manual freewheel lever forward) while the key is in
the “on” position, the scooter will not run until the manual freewheel lever is pushed rearward and the
key is turned to the “off” position, then back to the “on” position.
Main Circuit Breaker (Reset Button)
When the voltage in the batteries becomes low or your scooter is heavily strained because of excessive
loads, the main circuit breaker may trip to protect the motor and electronics from damage. When the
breaker trips, the entire electrical system shuts down. See figure 8.
The reset button pops out when the breaker trips.
Allow a minute or so for the electronics to “rest.”
Push in the reset button to reset the breaker.
If the breaker trips frequently, you may need to charge the batteries more often or have your authorised
Pride Dealer perform a load test on the batteries.
If the main circuit breaker trips repeatedly, see your authorised Pride Dealer for service.
SECURING THE SCOOTER
Always secure the unoccupied scooter in a forward-facing position in the vehicle. Attach the four tie-down
straps to the designated securement points. See figures 9 and 9A. Tighten the straps to sufficiently remove
all slack. Never attach tie-downs to adjustable, moving or removable parts of the scooter such as armrests,
shrouds and wheels. These items should be removed. Position the anchor points for the rear tie-down straps
directly behind the rear securement points on the scooter. The front tie-down straps should anchor to floor
points that are spaced wider than the scooter to provide increased lateral stability.
WARNING! Ensure unoccupied scooters are properly secured to the motor vehicle during
transport. Scooters that are not properly secured can become a hazard to the user and
to other vehicle passengers in the event of a crash, sudden stopping or swerving, as the
scooter could tip or slide out of place.
III. YOUR SCOOTER
Figure 9. Front Section
Figure 9A. Rear Section
FRONT SECUREMENT POINTS
REAR SECUREMENT POINT
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pride Colt Pursuit at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pride Colt Pursuit in the language / languages: English as an attachment in your email.

The manual is 4,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info