668233
35
Zoom out
Zoom in
Previous page
1/42
Next page
Celebrity X www.pridemobility.com 35
IX. BASIC TROUBLESHOOTING
Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that
may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because
the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.
DIAGNOSTIC FLASH CODES
The diagnostic flash codes for your scooter are designed to help you perform basic troubleshooting quickly
and easily. A diagnostic flash code will flash from the status LED in the event one of the conditions listed
below develops.
NOTE: Your scooter will not run unless the flash code condition is resolved and the scooter has been
turned off, then turned back on.
FLASH CODE CONDITION SOLUTION
(1) Battery charge is low. Charge batteries as soon as possible.
(2) Battery charge is too low to operate Charge the batteries.
the scooter.
(3) The scooter’s battery voltage is too Unplug the charger and/or turn the key off,
high to operate the scooter, or the then on.
charger is still connected to the
charger port.
(4) Current limit time out. Turn the scooter off for a few minutes, then
turn the scooter back on.
(5) The manual freewheel lever is in the Remove the key from the key switch, then
freewheel (forward) position. push the manual freewheel lever to the
drive (rearward) position, and power up the
scooter.
(6) Throttle control lever not at center Return the throttle control lever to the
position at start up. center position, turn the scooter off, then
turn the scooter back on.
(7) Speed pot error. Contact your authorized Pride Provider.
(8) Motor volts error. Contact your authorized Pride Provider.
(9) Other internal errors. Contact your authorized Pride Provider.
What if all the systems on my scooter seem to be “dead”?
Make certain that the key is in the “on” position.
Check that the batteries are fully charged.
Push in the main circuit breaker reset button. See IV. “Your Scooter.”
Make certain that both battery harnesses and the front-to-rear harness are firmly connected. See VIII. “Dis-
assembly and Assembly.”
Be sure the power down timer feature hasn’t been activated. See VI. “Operation.”
What if my scooter does not move when I engage the throttle control lever?
When the manual freewheel lever is pushed forward, the brakes are disengaged and all power to the motor/
transaxle assembly is cut.
Push rearward on the manual freewheel lever, turn the scooter off and then turn the scooter on to return to
normal scooter operation.
35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pride Celebrity X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pride Celebrity X in the language / languages: English as an attachment in your email.

The manual is 3,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info