721982
28
Zoom out
Zoom in
Previous page
1/44
Next page
28 www.pridemobility.com Artemis
11. Use wire ties to secure the controller harness and the
manual recline lever cable to the armrests.
12. Route the controller harness to the front of the power base
and reconnect the controller. See figure 21.
To extend the controller:
1. Loosen the setscrews in the mounting block. See figure 19 or 20.
2. Slide the controller into or out of the mounting block to the
desired position.
3. Tighten the setscrews to secure the controller.
Anti-Tip Wheels
The anti-tip wheels are designed to give your power chair
increased stability on rough surfaces. The anti-tip wheels are preset
at the factory for smooth surfaces or indoor use only. If you plan
on using your power chair on rough surfaces, it may be necessary
to adjust the anti-tip wheels to better suit your needs. The anti-tip
wheels may need adjustment if either of the following occur:
When accelerating, your power chair tips rearward
excessively.
The anti-tip wheels constantly rub the ground.
WARNING! Consult your Quantum Rehab
Dealer before attempting to change the anti-
tip wheel height! Changing the anti-tip wheel
height affects handling under deceleration!
WARNING! The higher you raise the anti-tip
wheels, the more you increase your power
chair’s tendency to tilt rearward when
accelerating. You can compensate for this by
having your Quantum Rehab Dealer make a
small adjustment to the pre-programmed
acceleration setting in the controller or by
adjusting the seat assembly.
WARNING! The anti-tip wheels may cause
trouble when ascending or descending a kerb
if they are not adjusted correctly. Contact
your Quantum Rehab Dealer for more
information.
IV. COMFORT ADJUSTMENTS
Figure 21. Controller Harness Routing
Figure 22. Anti-Tip Wheel Assembly
ANTI-TIP
WHEEL
BRACKET
BOLTS
ANTI-TIP
WHEEL
To adjust the anti-tip wheels:
1. Remove both bolts from the ani-tip wheel bracket. See figure 22.
2. Raise or lower the anti-tip wheel in 1.25 cm (0.5 in.) increments by aligning the appropriate adjustment holes.
See figure 22.
3. Reininstall and tighten both holes.
4. Raise or lower the other anti-tip wheel so that it is at the same height.
PROHIBITED! Do not remove the anti-tip wheels.
NOTE: Each drive tyre must be inflated to the the psi/bar/kPa air pressure rating indicated on each tyre in
order for the anti-tip wheels to be properly adjusted. The user must also be seated in the power chair in order
to properly adjust the anti-tip wheels.
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pride Artemis at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pride Artemis in the language / languages: English as an attachment in your email.

The manual is 4,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info