636654

President VALERY Classic Manual

26
Zoom out
Zoom in
Previous page
1/48
Next page
26
English
OUTPUT RADIUS PATTERNS
Zum
chassis
Connected
to chassis
Zum
starter
Towards
starter
a) Choosing your antenna:
- For CB radios, the longer the antenna, the better its results. Your dealer will
be able to help you with your choice of antenna.
b) Mobile antenna:
- Must be fixed to the vehicle where there is a maximum of metallic surface (ground plane),
away from windscreen mountings.
- If you already have a radio-telephone antenna installed, the CB antenna should be
higher than this.
- There are two types of antenna: pre-regulated which should be used on a good ground
plane (e.g. car roof or lid of the boot), and
. adjustable which offer a much larger range and can be used on a smaller ground
plane (see p 27 § 5, Adjustment of SWR).
- For an antenna which must be fixed by drilling, you will need a good contact between
the antenna and the ground plane. To obtain this, you should lightly scratch the surface
where the screw and tightening star are to be placed.
- Be careful not to pinch or flatten the coaxial cable (as this runs the risk of break down
and/or short circuiting).
- Connect the antenna (B).
c) Fixed antenna:
- A fixed antenna should be installed in a clear a space as possible. If it is fixed to a
mast, it will perhaps be necessary to stay it, according to the laws in force (you should
seek professional advice). All PRESIDENT antennas and accessories are designed to
give maximum efficiency to each CB radio within the range.
3) POWER CONNECTION:
Your PRESIDENT VALERY is protected against an inversion of polarities. However, before
switching it on, you are advised to check all the connections. Your equipment must be
supplied with a continued current of 12 volts (A). Today, most cars and lorries are negative
earth. You can check this by making sure that the negative terminal of the battery is
connected either to the engine block or to the chassis. If this is not the case, you should
consult your dealer.
WARNING: Lorries generally have two batteries and an electrical installation of 24 volts,
in which case it will be necessary to insert a 24/12 volt converter (type CV 24/12 PRESIDENT)
into the electrical circuit. The following connection steps should be carried out with the
power cable disconnected from the set.
a) Check that the battery is of 12 volts.
b) Locate the positive and negative terminals of the battery (+ is red and - is black). Should
it be necessary to lengthen the power cable, you should use the same or a superior
type of cable.
c) It is necessary to connect your CB to a permanent (+) and (-). We advise you to connect
the power cable directly to the battery (as the connection of the CB cable to the wiring
of the car-radio or other parts of the electrical circuit may, in somecases, increase the
likelihood of interference).
d) Connect the red wire (+) to the positive terminal of the battery and the black (-) wire to
the negative terminal of the battery.
e) Connect the power cable to your CB radio.
WARNING: Never replace the original fuse (2 A) by one of a different value.
4) BASIC OPERATIONS TO BE CARRIED OUT BEFORE USING YOUR SET
… 26 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for President VALERY Classic at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of President VALERY Classic in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 1,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info