12
JUMP START A VEHICLE
1. Make sure the booster MPB-6000 is fully charged.
2. Turn off all vehicle accessories (radio, air conditioner, etc.) before using the booster
3. Connect the POSITIVE (+) RED clamp from the booster clamp to the positive post of the vehicle bat-
tery.
4. Connect the NEGATIVE (-)BLACK clamp to the negative post of the vehicle battery.
5. Plug the jumper cable connector into the 12 V connector (6) of the booster MPB-6000. Make sure the
connection is solid.
6. Press POWER (5) to turn on the booster MPB-6000.
7. Turn on the vehicle ignition key for 3 seconds maximum.
If the vehicle starts:
• Disconnect rst the jumper cables from the MPB-6000 (6), then the clamps from the battery.
If the vehicle does not start:
• Wait 1 minute and try again.
8. Turn off the booster MPB-6000, slide ON/OFF (7) to “OFF”.
CHARGING A 5 V USB DEVICE (TABLET, CELL PHONE, ETC.)
1. Connect the 2-1 USB cord to the USB output (3) of the booster MPB-6000
2. Connect your device to either the mini USB or micro USB cable.
1. Press POWER (5) to turn on the booster MPB-6000.
4. The MPB-6000 begins to charge your device.
5. When your device is completely charged, turn off the booster MPB-6000.
TURN ON FLASHLIGHT
1. Long press (3 seconds) POWER (5) turns on the LED ashlight
2. Short press POWER (5) again to cycle through the 3 modes: Strobe S.O.S / Fast Strobe / OFF.
3. Press POWER (5) to turn off MPB-6000.
COMPACT TIRE INFLATOR
• This is not a toy. Please keep out of reach of children
• Do NOT leave the compressor unattended when in operation
• Make sure to stay safe and away from trafc if you have to inate tires at roadside
• Do not use and expose the compressor to re, ammable liquids, gases or dust
• Avoid pouring or splashing water or any other liquids on the compressor
• In case of electrical or mechanical malfunction, immediately switch off the compressor and unplug it
• If the recommended pressure is exceeded, an explosion may result and there is a risk of personal
injury. Do NOT exceed the recommended pressure.
• The compact tire inator cannot be serviced by the user.
This compact tire inator is designed for short term operation only. Maximum running time
should not exceed 15 minutes and a 15 minutes cool-down period is recommended before
operating the compressor again.