636606

President Jackson II Classic Manual

29
Zoom out
Zoom in
Previous page
1/52
Next page
29
4) BASIC OPERATIONS TO BE CARRIED OUT BEFORE USING
YOUR SET FOR THE FIRST TIME (without transmitting and
without using the «push-to-talk» switch on the microphone)
a) Connect the microphone
b) Check the antenna connections
c) Turn the set on by turning the volume knob (1) clockwise.
d) Turn the squelch knob (2) to minimum (M position).
e) Adjust the volume to a comfortable level.
f) Go to Channel 20 using either the «UP» «DN» key on the microphone or the
rotary knob (6).
5) ADJUSTMENT OF SWR (Standing wave ratio)
WARNING: This must be carried out when you use your CB radio for the first
time (and whenever you re-position your antenna). The adjustment must be
carried out in an obstacle-free area.
* Adjustment with the built-in SWR meter
- Set the CB to channel 20 in FM.
- Turn the RF POWER (1) to maximum,
- Put the switch (15) on the to position CAL (calibration).
- Press the «push-to-talk» switch (18) on the microphone to transmit.
- Bring the index needle to of the Meter by using the calibration key CAL (2).
- Change the switch (15) to position SWR (reading of the SWR level). The reading
on the meter should be as near as possible to 1. If this is not the case, re-adjust
your antenna to obtain a reading as close as possible to 1. (An SWR reading
between 1 and 1.8 is acceptable).
- It will be necessary to re-calibrate the SWR meter after each adjustment of
the antenna.
* Adjustment with an external SWR meter (e.g. TOS-1 PRESIDENT)
a) To connect the SWR meter :
- Connect the SWR meter between the CB radio and the antenna as close as
possible to the CB (use a maximum of 40 cm cable, type President CA 2C).
b) To adjust the SWR meter:
- Set the CB to channel 20 in FM.
- Turn the RF POWER (1) to maximum,
- Put the switch on the SWR meter to position FWD.
- Press the «push-to-talk» switch (18) on the microphone to transmit.
- Bring the index needle to ▼, ∞ or SET by using the calibration key CAL.
- Change the switch to position REF (reading of the SWR level). The reading on
the Meter should be as near as possible to 1. If this is not the case, re-adjust
your antenna to obtain a reading as close as possible to 1. (An SWR reading
between 1 and 1.8 is acceptable).
- It will be necessary to re-calibrate the SWR meter after each adjustment of
the antenna.
WARNING: In order to avoid any losses and attenuations in cables used for
connection between the radio and its accessories, PRESIDENT recommends
to use a cable with a length inferior to 3m.
Your CB is now ready for use.
B) HOW TO USE YOUR CB
1) ON/OFF - VOLUME ~ RF POWER
ON/OFF - VOLUME
a) To turn the set on, turn the knob (1) clockwise.
b) To increase the sound level, turn the same knob further clockwise.
RF POWER
Adjustment of the output power in AM and FM mode only. Allows reducing
the power in case of a nearby communication with a person who has no RF
GAIN.
The normal position of this function is set to maximum, fully clockwise.
2) ASC (Automatic Squelch Control) SQUELCH ~ CAL
SQUELCH
Suppresses undesirable background noises when there is no communication.
Squelch does not affect neither sound nor transmission power, but allows a
considerable improvement in listening comfort.
a) ASC: Automatic Squelch Control
Worldwide patent, a PRESIDENT exclusivity.
Turn the squelch knob (2) anti-clockwise into ASC position. The «ASC/VOX»
led lights up into green.
Note: If the VOX function is also active, the led lights up into orange.
No repetitive manual adjustment and a permanent improvement in listening
comfort when ASC is active. This function can be disconnected by turning
the switch clockwise. In this case the manual squelch control becomes active
again. The «ASC/VOX» led turns off.
b) MANUAL SQUELCH
Turn the squelch knob clockwise to the exact point where all background
noise disappears. This adjustment should be done with precision as, if set to
maximum (fully clockwise) only the strongest signals will be received.
English
… 29 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for President Jackson II Classic at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of President Jackson II Classic in the language / languages: English, French, Polish, Spanish as an attachment in your email.

The manual is 1,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info