Page 2
IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the product
for future reference.
BEFORE USE
You must inspect the appliance including its cable and plug for any signs of
damage. If the product is damaged, DO NOT use it, and contact your supplier
immediately.
INSTALLATION
For free-standing use: Attach the feet to the underneath of the heater using the
four 12mm (½") screws (two in each foot)
To wall-mount: Referring to the diagram opposite, draw two horizontal lines on
the wall 258 mm (10¼") apart, the lower line more than 50 mm (2") from the floor.
On the upper line, drill holes 260 mm (10¼") from the centre line, using a 6 mm
(¼") masonry bit, and insert a wall plug.
On the lower line, drill holes 266 mm (10½") from the centre line using a 6 mm
(¼") masonry bit, and insert a wall-plug.
Fix the two hook-brackets to the upper holes using the 30 mm (1¼") screws.
Fix the two L-shaped brackets to the underside of the, using the 12 mm (½")
screws
Hang the heater on the hook-brackets using the two 25 mm (1") slots.
The L-shaped brackets will now line up with the lower holes in the wall. Attach to
the wall using the other two 30 mm (1¼") screws.
