558625
6
Zoom out
Zoom in
Previous page
1/15
Next page
Page 6
If the mains lead is damaged, it must be replaced by the manufacturer or an
authorised service centre. If the mains plug needs to be replaced, proceed as
follows:
Connect the brown wire to the
terminal labelled "L".
Connect the blue wire to the terminal
labelled "N".
Connect the green/yellow wire to the
terminal labelled with the earth
symbol or "E".
Make sure that the cord-grip is
positioned correctly (over the outer
sheath of the cable) and it fully
tightened.
If the plug is fitted with a 13 A fuse, replace it by a 5 A fuse.
FAULT FINDING
Appliance does not operate when switched on:
There is a 3 minute delay before the compressor starts. This is to protect the
compressor.
Appliance stops operating and "FULL" indicator lights.
Bucket is full of water - empty the water as shown on page 6. Do not drink the
water (it may be used for watering plants).
Bucket is not replaced properly. Ensure that the bucket is correctly aligned with
the housing.
Appliance stops operating and P1 is displayed.
This happens if the temperature is lower than 10 °C, and ice begins to form on
the internal heat exchanger. The defrost cycle will last for a few minutes, and
then operation will resume.
Appliance operates intermittently.
The humidity in the room has reached the level set on the humidistat control.
Very little water is extracted.
There is very little humidity in the air (this happens during dry sunny weather,
and also during very cold weather). Condensation on windows is caused by the
difference between indoor and outdoor temperatures, and is not a good indicator
of the level of humidity.
The room remains humid and little water is extracted
The humidity setting is too high, press the ˜ button to reduce the required
humidity level.
The area to be dehumidified is too large
6


Need help? Post your question in this forum.

Forumrules
1

Forum

prem-i-air-eh1461

Reset search

  • Can not turn dehumidifier on but when I take water tray out P2 illuminates on menu then goes out when tray refitted. Cleaned out filter and checked continuity To circuit boards but just can’t manually turn it on. Any help please much appreciated Submitted on 7-6-2020 at 14:02

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Prem-i-air EH1461 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Prem-i-air EH1461 in the language / languages: French as an attachment in your email.

The manual is 2,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Prem-i-air EH1461

Prem-i-air EH1461 User Manual - English - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info