558833

Prem-i-air EH1432 Manual

5
Zoom out
Zoom in
Previous page
1/12
Next page
If the lamp providing the flame effect fails, it can be replaced
as follows:
Disconnect from the mains supply and remove the cover
from the back panel labelled "please change the bulb here".
Remove the failed lamp, and replace by a new 40 W lamp
with a small Edison screw (E14) base.
Replace the cover.
FAULT-FINDING
The EH1432 has a tilt switch which disconnects the power if
the heater falls over. If the heater is not operating, restore it
to an upright position.
The EH1432 has an overheat protection switch, which
disconnects the power if the element gets too hot. The usual
reason for this is because the air-flow has been obstructed,
or the grilles have been blocked. If the heater ceases to
operate, leave it for 20 minutes to cool down, then check that
the grilles are not being obstructed.
Select "Flame effect only" on the switches, and reconnect to
the mains supply. If the flame effect operates, then it is safe
to select the "low heat" or "high heat" settings. If the flame
effect does not operate, or overheat protection switch
operates again, contact an authorised service agent for
repair.
Page 5
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Prem-i-air EH1432 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Prem-i-air EH1432 in the language / languages: English, French as an attachment in your email.

The manual is 0,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info