OPERATION
Plug the mains lead into a 13 Amp mains socket.
If connecting via an extension lead, make sure that the lead
is rated at 13 Amps or more, and that it is fully unwound.
Switch the unit on at the mains socket.
Move the 3-position switch on the timer to the "I" position
Use the rotary power control switches on the side to select
the required operation:
• O = OFF
• I = Low Heat (1100 W)
• II = Medium heat (1400 W)
• III = High Heat (2500 W)
Unplug the heater from the mains when not in use.
USING THE THERMOSTAT
The thermostat can be use to regulate the room temperature.
Turn both switches on (high heat), and rotate the
temperature control fully clockwise.
The heater will then operate at maximum output. When the
desired temperature is reached, rotate the temperature
control anticlockwise until a click is heard. The heater will
then switch on and off to keep the room at the desired
temperature. The indicator light will show that this is
happening.
Either the low, medium or high heat setting can be used.
USING THE TIMER
The numbers around the timer dial show the time in 24-hour
clock.The timer is controlled by the plastic segments - each
segment represents 15 minutes. Move the segment outwards
if the heater should be ON for that time period, or inwards
towards the centre of the dial if it should be OFF.
Page 4
